Error messages
Display message Cause/solution
Error RRecording was too short. Try again.
Failed RPhonebook copy failed (page 16). Confirm the other handset
(the receiver) is in standby mode and try again.
Incomplete RThe receiver’s phonebook memory is full. Erase the unwanted
phonebook entries from the other handset (the receiver) and
try again.
Memory Full RThe phonebook memory is full. Erase unwanted entries
(page 16).
Messages Full RMessage memory is full. Erase unwanted messages
(page 25, 26).
No link to base.
Reconnect AC
adaptor.
RThe handset has lost communication with the base unit. Move
closer to the base unit and try again.
RUnplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
RThe handset’s registration may have been cancelled.
Re-register the handset (page 38).
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit’s
AC adaptor and turn off the handset, then reconnect the base unit’s AC adaptor and turn on the
handset.

General use

Problem Cause/solution
The handset does not turn
on even after installing
charged batteries.
RPlace the handset on the base unit or charger to turn on the
handset.
The unit does not work. RMake sure the batteries are installed correctly (page 9).
RFully charge the batteries (page 9).
RCheck the connections (page 9).
RUnplug the base unit’s AC adaptor to reset the unit and turn
off the handset. Reconnect the adaptor, turn on the handset
and try again.
RThe handset has not been registered to the base unit.
Register the handset (page 38).
The handset display is
blank.
RThe handset is not turned on. Turn the power on (page 12).
34
Useful Information
TG2721_22AL(en)_0730_ver001.pdf 34TG2721_22AL(en)_0730_ver001.pdf 34 2012/07/30 16:53:052012/07/30 16:53:05