Programmable Settings
Programming via direct commands
You can program features using “direct commands”– special codes that take you directly to the feature you wish to program and allow you to select the desired setting. There is no need to scroll through the unit’s
Details of each feature can be found on the corresponding pages.
Important:
L Before programming, make sure the unit is not being used. 1 Press {MENU} ({F2} key).
2 Press {#}.
Enter direct No.
:
BACK
3
4
5
6
Enter the desired feature code (shown below).
Enter the desired setting code (shown below).
L This step may vary depending on the feature being programmed.
Press {SAVE} ({F3} key).
Press {STOP} to exit programming mode.
Note:
L If the unit beeps 5 times, you entered an invalid code. Enter the correct code. L If you enter the wrong code, press {CLEAR}.
L To exit programming, press {STOP} at any time.
Direct commands chart
Note:
L The default settings are indicated by *.
Feature | Feature code | Setting code | Page |
|
|
|
|
Ringer volume | {1} {6} {0} | {1}: Low {2}: Medium | page 23 |
|
| {3}: High* {0}: Off |
|
|
|
|
|
Ringer tone | {1} {6} {1} | page 23 | |
|
|
|
|
LCD contrast | {1} {4} {5} | page 23 | |
|
|
|
|
Key tone | {1} {6} {5} | {1}: On* {0}: Off | page 25 |
|
|
|
|
Set area code | {2} {5} {5} | Go to step 2 on page 24. | page 24 |
|
|
|
|
20
