Replacing Belt
Lift Agitator Up
Unidad del agitador Soulever l'agitateur
➢Replace belt whenever a burning rubber smell caused by excessive slippage occurs.
➢Place
➢Remove lower plate.
➢Remove agitator by carefully lifting out.
Motor Shaft |
|
Eje del motor |
|
Arbre d'entraînement | |
du moteur | Selector Shaft |
| |
| Eje du selector |
| |
| Arbre du sélecteur |
| tapis/plancher |
| End Cap | |
Groove | Tapa del | |
Ranura | extremo | |
Bouchon | ||
Ouverture | ||
|
➢Remove worn or broken belt.
➢Loop new belt (Panasonic Type UB8 only) around motor shaft and brush pulley; see illustration for correct belt routing.
➢Clean agitator and reinstall the two
(2) end caps.
➢Reinstall agitator back into nozzle housing grooves.
➢After reinstalling the agitator, turn it by hand to make sure that belt is not twisted or pinched and that all rotating parts turn freely.
➢Reinstall lower plate.
Cleaning Agitator
➢Clean agitator after every five uses.
➢ Turn vacuum over, exposing the agitator.
➢ Cut off any carpet pile and lint entangled around agitator with a pair of scissors.
- 34 -
