Panasonic NV-FJ710 Series operating instructions How to install the satellite receiver

Connecting the VCR to a Satellite Receiver or Digital Receiver

Satellite receiver here includes a digital receiver.

The connection method differs depending on the type of your satellite receiver.

For details about the connection, also read the satellite receiver’s operating instructions.

If the Satellite Receiver is Equipped with a 21-pin Scart Socket

If your satellite receiver is equipped with a 21-pin Scart socket, use a 21-pin Scart cable to connect the VCR.

For the connection to the TV, refer to pages 10 and 12.

Be sure to keep the VCR, TV and satellite receiver switched off until you have finished all connections.

For your safety, do not connect or handle the equipment with wet hands.

g

Satellite receiver (not supplied)

		1
2	21-pin Scart socket
To an AC Mains socket
	≥If your satellite	21-pin Scart cable
	receiver has a VCR	(not supplied)
	socket, connect the
	cable to it.

1Connect a 21-pin Scart cable (not supplied) to the AV2 21-pin Scart socket g on the VCR and to the 21-pin Scart socket on the satellite receiver.

2Connect the satellite receiver’s mains lead to an AC mains socket.

3Set “AV2” to “TIMER” or “EXT”. For details, see page 50.

If the Satellite Receiver Is Not Equipped with a 21-Pin Scart Socket

In case your satellite receiver is not equipped with a 21-pin Scart socket, use the RF coaxial cable to connect it to the VCR.

For the connection to the TV, refer to pages 10 and 12.

Be sure to keep the VCR, TV and satellite receiver switched off until you have finished all connections.

For your safety, do not connect or handle the equipment with wet hands.

	Aerial (not supplied)
Satellite receiver	Aerial Input socket
(not supplied)		Aerial lead
		(not supplied)
		1
3	Aerial Output
	socket

To an AC mains socket

2

i	RF coaxial cable
	(not supplied)

1Connect the aerial lead to the Aerial Input socket on the satellite receiver.

2Connect the RF coaxial cable to the Aerial Output socket on the satellite receiver and to the Aerial Input socket i on the VCR.

3Connect the satellite receiver’s mains lead to an AC mains socket.

Hint:

≥The RF output channel of the satellite receiver should be adjusted away from channel 36, which is used by the VCR, e.g. re-adjust to channel 33.

Note:

How to install the satellite receiver

Carefully observe the following points so that you can control the satellite receiver from the VCR.

1Place the satellite receiver on top of the VCR.

2Move the satellite receiver back a few centimetres so that infra-red signals emitted from the top of the VCR’s front panel can be received by the satellite receiver.

Satellite receiver

Infra-red signal transmitter [

21-pin Scart cable or RF coaxial cable

VCR

38