Others

Flash

While recording to a tape

 

During demo mode

 

When continuous

 

photoshot is used

 

When the colour night

 

view function is used

 

 

Zoom

When the microphone of

microphone

the free style remote

Wind noise

control or an external

reduction

microphone is used

 

 

Scene mode

When setting the [AUTO/

 

MANUAL/FOCUS] switch

 

to [AUTO]

 

When the colour night

 

view function is used

 

 

Change of

When digital zoom

white balance

(10k or higher)

 

is used

 

When the colour night

 

view function is used

 

When a menu is

 

displayed

 

 

Adjusting the

When the colour night

shutter speed,

view function is used

iris/gain

When the scene mode is

 

used

 

 

Variable-speed

During repeat playback

search

 

 

 

Deleting files

When the write protect

 

switch on the card is set

 

to [LOCK]

 

When the file is protected

 

 

Formatting

When the write protect

 

switch on the card is set

 

to [LOCK]

 

 

Audio dubbing

The section of a tape

 

recorded in LP mode

 

The blank section of a

 

tape

 

Sounds sent through the

 

DV terminal

 

 

Before requesting repair (Problems and solutions)

Power/Body

1:The movie camera power cannot be turned on.

Is the battery fully charged? Use a fully charged battery.

The battery protection circuit may have operated. Attach the battery to the AC adaptor for 5 to 10 seconds. If the movie camera still cannot be used, the battery is faulty.

2:The movie camera power is turned off automatically.

If you set [POWER SAVE] to [5 MINUTES] and do not operate the movie camera for about

5 continuous minutes, the power is automatically turned off for tape protection and power conservation. To resume recording, turn the [OFF/ON] switch to [OFF]. Then turn it to

[ON] again. (-44-)

3:The movie camera power does not stay on long enough.

Is the battery low? If the remaining battery power indication is flashing or the message “LOW BATTERY” is displayed, the battery has run down. Charge the battery or attach a fully charged battery. (-8-)

Has condensation occurred? When you carry the movie camera from a cold place into a warm place, condensation may occur inside it. If so, the power is turned off automatically, disabling all operations except for taking cassettes out. Wait until the condensation

indication disappears. (-52-)

4: Battery runs down quickly.

Is the battery fully charged? Charge it with the AC adaptor. (-8-)

Are you using the battery in an extremely cold place? The battery is affected by ambient temperature. In cold places, the operating time of the battery becomes shorter.

Has the battery worn out? The battery has a limited life. If the operating time is still too short even after the battery is fully charged, depending on the usage, the battery has worn out and can no longer be used.

5:The movie camera cannot be operated though powered up.

The movie camera does not operate normally.

49

VQT0N50

Page 49
Image 49
Panasonic NV-GS150GN Before requesting repair Problems and solutions, Power/Body Movie camera power cannot be turned on