Before using

ªInstall a button-type battery

Install the button-type battery supplied in the remote control before using it.

1While pressing the stopper 1, pull out the battery holder.

1

2Set the button-type battery with its (i) mark facing upward and get the battery holder back in place.

Caution

Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the equipment manufacturer. Discard used batteries according to manufacturer’s instructions.

Warning

Risk of fire, explosion and burns. Do not recharge, disassemble, heat above 100 xC or incinerate. Keep the Button-Type battery out of the reach of children. Never put Button-Type battery in mouth. If swallowed call your doctor.

ªRemote control usable range

The distance between the remote control and the camera: Within approx. 5 m

Angle: Approx. 10o up and 15o down, left, and right

ªSelecting the remote control mode

If 2 cameras are used simultaneously, set the mode for one pair of movie camera and remote control to [VCR1] and that of the other pair to [VCR2]. This will prevent interference between the 2 pairs. (The default setting is [VCR1]. When the button-type battery is replaced, the setting will revert to the default [VCR1].)

1 Setting on the camera:

Set [SETUP] >> [REMOTE] >> [VCR1] or [VCR2].

2 Setting on the remote control:

2 1

[VCR1]:

Press [D] and [] simultaneously. 1 [VCR2]:

Press [E] and [] simultaneously. 2

ªConcerning the button-type battery

When the button-type battery runs down, replace it with a new battery (part number: CR2025). The battery is normally expected to last about 1 year, but it depends on operation

frequency.

Keep the button-type battery out of the reach of children.

If the remote control mode of the camera and that of the remote control do not match with each other, “REMOTE” will appear. When the remote control is operated for the first time after the camera is turned on, “CHECK REMOTE

MODE” (-47-) will appear and operation is impossible. Set the same remote control mode.

The remote control is intended for indoor operation. Outdoors or under strong light, the movie camera may not operate properly even within the usable ranges.

Within a 1 metre range, you can operate the remote control from beside the remote control sensor (LCD monitor side) of the movie camera.

17

VQT0T93

Page 17
Image 17
Panasonic NV-GS180GN Install a button-type battery, Remote control usable range, Selecting the remote control mode