Preparation
About Your Projector
Remote control
Power button
While MAIN POWER is on, switch between standby mode and projection mode.
Remote control signal emitter
Emit remote control signal.
Display the PICTURE menu or ADVANCED MENU.
Switch to cycle through the
PICTURE MODE.
Display the VIERA LINK
MENU.
Display the main menu or return to the previous menu.
Navigate through the menus with 
▼ ◄ ►, and activate the menu item with the ENTER button.
Open the connected equipment menu while using the VIERA Link.
Switch to cycle through the input method.
Button backlight
When any button is pressed, the button backlight is lit. Without any operation, it gets darker after 5 seconds and goes off after next 5 seconds.
Display the ZOOM/FOCUS menu.
Display the MEMORY LOAD menu.
Capture the projected image as a still image.
Display the input waveform.
Reset some of the settings to the factory default.
Return to the previous menu.
Activate the assigned function from the menu options for shortcut.
Preparation
Battery compartment
111 Press the tab and lift up the cover.
222 Insert the batteries according to the polarity diagram indicated inside.
Note:
•• See the functional instructions that is in the provided
•• Do not drop the remote control.
•• Avoid contact with liquids or moisture.
•• Use manganese batteries or alkaline batteries with the remote control.
•• Do not attempt to modify or disassemble the remote control. Contact an Authorised Service Centre for repairs.
•• Do not keep pressing the remote control buttons as this may shorten battery life.
