Precautions for Use

Cautions when transporting

zzWhen transporting the projector, be careful not to touch the mirror.

zzWhen transporting the projector, hold it securely by its bottom and avoid excessive vibration and impacts. Doing so may damage the internal parts and result in malfunctions.

zzDo not transport the projector with the adjustable feet extended. Doing so may damage the adjustable feet.

Cautions when installing

JJDo not set up the projector outdoors.

The projector is designed for indoor use only.

JJDo not use under the following conditions.

zzPlaces where vibration and impacts occur such as in a car or vehicle: Doing so may damage the internal parts and result in malfunctions.

zzNear the exhaust of an air conditioner: Depending on the conditions of use, the screen may fluctuate in rare cases due to the hot air from the air exhaust port or the heated or cooled air. Make sure that the exhaust from the projector or other equipment, or the air from the air conditioner does not blow toward the front of the projector.

zzNear lights (studio lamps, etc.) and other locations of great temperature fluctuation (“Operating environment” (Æ page 75)): Doing so may shorten the life of the lamp or result in deformation of the outer case and malfunctions.

zzNear high-voltage power lines or near motors: Doing so may interfere with the operation of the projector.

zzPlace where there is high-power laser equipment: Directing a laser beam onto the lens surface causes damage to the DLP chips.

JJBe sure to ask a specialized technician when installing the product to a ceiling or wall.

This requires an optional ceiling mount bracket.

Model No.: ET-PKV100H (for high ceilings), ET-PKV100S (for low ceilings), ET-PKC200B (Projector Mount Base), ET-PKC200W (Wall Mount Bracket).

JJLens focus

The high clarity projection lens is thermally affected by the light from the light source, making the focus unstable in the period just after switching on the power. Wait at least 30 minutes with the image projected before adjusting the lens focus.

JJWhen using the projector at elevations below approx. 1 000 m (3 300 ft), make sure [High altitude] is set to [Off].

Failure to do so may shorten the life of the internal parts and result in malfunctions.

JJWhen using the projector at elevations approx. 1 000 m (3 300 ft) and approx. 3 000 m (10 000 ft), make sure [High altitude] is set to [On].

Failure to do so may shorten the life of the internal parts and result in malfunctions.

JJDo not install the projector at elevations approx. 3 000 m (10 000 ft) or higher above sea level.

Failure to do so may shorten the life of the internal parts and result in malfunctions.

JJConfirm and set the using environment temperature [“Operating environment” (Æ page 75)].

Important Information

ENGLISH - 11