About Your Projector

Preparation

Remote control

(1)

(2)

(3)

(4)

(5)

(6)

(7)

(8)

 

(12)

<S-VIDEO> button

 

 

Switches to S-Video source.

 

(13)

<VIDEO> button

(11)

 

Switches to Video source.

(14)

<KEYSTONE +> button

 

(12)

 

Adjusts the image to compensate for distortion

(13)

 

caused by tilting the projector.

(15)

<IMAGE> button

 

(14)Selects the color mode among Dynamic, PC, Movie, Game and User.

(15)

(16) ▲▼◄► buttons

 

(16)Uses to operate menu.

(17)

(17) <AUTO ADJ.> button

Automatically synchronize the projector to the

 

 

input source.

(18)

(18) <ASPECT> button

Selects [Aspect Ratio] in [Screen].

(19) <VOLUME +/-> buttons

(9)

(19)

Increases/decreases speaker volume.

(10)

Attention

zzDo not drop the remote control. zzAvoid contact with liquids.

zzDo not attempt to modify or disassemble the remote control.

(1)Remote control signal emitter

(2)<COMPUTER> button

Switches COMPUTER 1 or COMPUTER 2 input. If either of the input is selected, press

<COMPUTER> button will switch to the other one.

(3)<v/b> button

Turns the projector on/off.

(4)<3D> button

Displays [3D] menu.

(5)<FREEZE> button

Temporarily stops the image and mute the sound. Press again to return to previous state.

(6)<MENU> button

Turns the main menu on/off.

(7)<INPUT> button

Displays [Source] menu. (Æ page 33)

(8)<MUTE> button

Temporarily mutes the sound.

Press again to return to previous state.

(9)<KEYSTONE -> button

Adjusts the image to compensate for distortion caused by tilting the projector.

Note

zzThe <AUTO ADJ.> operation may not optimize the image position or the resolution, depending on the input signal format or the image contents. In this case, switch to a different image and execute <AUTO ADJ.> again.

zzWhen pointing the remote control directly toward the projector (Remote control signal receiver), operating range for the remote control is within 8 m (26.25 ft). Also, operation range available for four directions (up, down, left, right to the projector) is ± 35° and the operation distance may become short.

zzIf there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate correctly.

zzYou can operate the projector by reflecting the remote control signal on the screen. The operating range may differ due to the loss of light caused by the properties of the screen.

zzWhen the remote control signal receiver is lit with a fluorescent light or other strong light source, the projector may become inoperative. Set the projector as far from the luminous source as possible.

zzYou can operate all of the functions of the projector via the remote control. Make sure not to lose the remote control.

zzBefore using the remote control for the first time, remove the transparent insulation tape.

(10) <AV MUTE> button

 

 

 

 

Transparent

Momentarily turns off/on the audio and video.

0Q2

&59

/7

6-

insulation tape

 

 

 

+

 

 

 

 

1

 

 

 

 

 

$

 

 

 

 

 

3

 

Press again to return to previous state.

 

 

 

$

 

 

/L& (/ /

 

 

 

(11)<HDMI> button

Switches to HDMI source.

16 - ENGLISH