Preparation
UsingRemoteRemotecon rolcontrol
Installing and Removing battery
1111 Press the guide and pull | 2222 Install new battery into | 3333 Put the battery base | ||
out the battery base. | the compartment. | back. | ||
| CR2023 |
| Remove the old |
|
|
| Lithium coin cell |
| |
| 5 | TS |
|
|
| VOL |
|
| |
|
|
| battery and install |
|
|
|
| new one (CR2025). | 3VOLTS |
|
|
| Ensure that the side |
|
|
|
| with a “+” is facing |
|
|
|
| up. |
|
Attention
zzWhen discarding a lithium coin battery, be sure both sides
Setting Remote control ID numbers
When you use the system with multiple projectors, you can operate all the projectors simultaneously or each projector individually using single remote control, if unique ID number is assigned to each projector.
After setting the remote control ID of the projector, set the same remote control ID to the remote control. There are 7 different remote control IDs: [All], [ID1]~[ID6], the initial remote control ID is [All].
JJSetting the remote control ID
1)While holding down the <MENU> key, press the <IMAGE> key. The number of times you press the <IMAGE> key corresponds to the desired remote control ID.
The number of times to press the <IMAGE> key is as follows:
ID1 = Once, ID2 = Twice, ID3 = 3 times, ID4 = 4 times, ID5 = 5 times, ID6 = 6 times.
2)The remote control ID is changed when the <MENU> button is released.
JJResetting the remote control ID
1)The remote control ID is reset to [All] (default) by pressing the <MENU> key and <IMAGE> key at the same time for 10 seconds or more.
Note
zz When operating the projector under [All] code, you can operate several projectors at the same time.
zzIf the <IMAGE> button is pressed 7 times or more, the remote control ID cannot be changed (the operation is invalid). zzFor setting the remote control ID codes, see [Remote ID] in the [Setting] menu. (Æ page 45)
zzIf the battery is not in use for a long period of time and is removed from the remote control, the remote control ID will be reset.
20 - ENGLISH