Panasonic PT-FW100NTE Computer connection guidance, Technical Information Cable specifications

Appendix

Technical Information

Cable specifications

(When connected to a personal computer)

	NC	NC
Projector	NC	NC PC (DTE)
	NC
		NC
	NC	NC

Control commands

Command	Control contents		Remarks
		In standby mode, all commands other than the PON command are
PON	Power ON	ignored.
		The PON command is ignored during lamp ON control.
		If a PON command is received while the cooling fan is operating after the
POF	Power OFF	lamp has switched off, the lamp is not turned back on again straight away
		in order to protect the lamp.
AVL	Volume	Parameter
		000 - 063 (Adjustment value 0 - 63)
		Parameter:
IIS	INPUT	VID = VIDEO	SVD = S-VIDEO
		RG1 = COMPUTER1	RG2 = COMPUTER2
		YUV = COMPONENT	NWP = NETWORK
	Lamp condition	Call back
Q$S		0 = Standby	2 = Lamp ON
	query
		1 = Lamp ON control active	3 = Lamp OFF control active
		Turning off the projection temporarily.
OSH	SHUTTER	Send the command to switch between ON and OFF.
		Do not send the command consecutively.

Computer connection guidance

You can switch the signals which to output from the COMPUTER1 OUT terminal by pressing the computer key command. The key commands are depend on the manufactures. If you select the computer terminals which has no signals while the INPUT GUIDE is set to DETAILED, the computer connection guidance will be displayed.

Manufacturer	Key command	Manufacturer	Key command	Manufacturer	Key command
		TOSHIBA		IBM	+
Panasonic				SONY
	+	SHARP	+
NEC
		HP		Apple
FUJITSU	+	EPSON	+	Other	+
		DELL

NOTE:

•The computer connection guidance will disappear after 5 minutes.

•Please refer the instructions which provided with the computers for more detailed information.

ENGLISH - 48