Panasonic PT-ST10EA 1 , 2 , 3

6

Network setting of the projector (cont.)

NETWORK

Wired LAN settings

You can make detailed wired LAN settings.

Select [WIRED LAN] in the NETWORK menu and press the [ENTER] button.

1

WIRED DETAILED SETUP

OK CANCEL

CANCEL

SELECT

DHCP

IP ADDRESS

SUBNETMASK

DEFAULT GATEWAY

192.168. 10.100

OFF

192.168. 10. 1

255.255.255. 0

DHCP

ON: If a DHCP server exists in the network to which the projector is connected, the IP address will automatically be

acquired.

OFF: If a DHCP server does not exist in the network to which the projector is connected, additionally set [IP

ADDRESS ], [SUBNETMASK ] and [DEFAULT GATEWAY ].

“Glossary” (See page 18)

Select each item with the [▲▼] buttons and change the settings following the

2 menu’s Operating guidance.

Select [OK] with the [▲▼] buttons and press the [ENTER] button.

3

Default network settings

The following settings are set before the projector leaves the factory.

DHCP OFF

IP ADDRESS 192.168.10.100

SUBNETMASK 255.255.255.0

DEFAULT GATEWAY 192.168.10.1

Contents

Main Contents Request Regarding Security What you can do Check your computer Necessary environment for computers to be connected Connecting with Wired LAN 1 Make the network setting according to your system administrator. 2 Network setting of the projector Displaying the NETWORK menu 1 Select [NETWORK] with the [] buttons. 2 1 2 3 NAME CHANGE You can change the projector name on the network. 1 LANGUAGE PROJECTOR SETUP SECURITY NETWORK POSITION DISPLAY OPTION PICTURE 2 1 LANGUAGE PROJECTOR SETUP SECURITY NETWORK POSITION DISPLAY OPTION PICTURE Select [ON] or [OFF] with the [] buttons. 1 2 button. Using WebBrowser 1 2 4 1 2 1 Click the [Security] tab and set the security level to [Default Level], or select [Custom 2 Accessing from the WebBrowser Start up the WebBrowser, and enter the IP address set to the projector. 1 Enter the User name and the Password. 2 Click [OK]. 3 Monitor information window Projector status Network status If [FAILED] appears 1 2 3 Click [Submit]. 4 Adjust clock E-mail set up ENABLE : Enable or disable email transmission. MAIL FROM : Enter the senders email address. MINIMUM TIME : Enter the interval for sending email. E-MAIL ADDRESS : Enter the email addresses of the recipients. Page Authentication set up Command port set up Change password window Password settings and symbols. Password (forced change) that logged in with administrator/user Switching Languages Using PJLink protocol Querying the projector status Applicable commands PJLink security authentication Glossary Trademarks