Panasonic PV-D4762 Review, Replace or Clear Program Contents, To Replace program

*Important: If a remote control button does not work when pressed, press the VCR button on the remote and try the button again.

Review, Replace or Clear Program Contents:

(Recording is not in progress)

1Pressto displayPROGProgram List.

2	DT	STA		R T	ST	O P	CH	SPD	Press
	7		9 : 00A 12 : 00A				08	SP	to select number and
	10		8: 00P		9: 00P		10	SP
	8	10 : 00P			12	: 00P	02	SP
	S U		9: 00P		10 : 00P		L1	LP	press SET
	C AN		C EL	: A DD		/ DLT			to display.
	SELECT			1-8 :
	ENTER			: SET
	EXIT			: PROG

To cancel a Timer

Recording in progress...

Hold down STOP on VCR mode for

a few seconds to cancel the Timer Recording.

(The “TIMER” Indicator goes out on Multi Function Display.)

•Any future daily or weekly recording will be performed as programmed.

3 To Replace program...

DAT	E		S TART	S TOP			CH	Repeat Step 2 (p. 24)
7 SUN			9:00A	12	:00A		08	to set new programs.
T OD A Y							SP
----------------------------------------
SE L E C		T	START	D AT	E
SELE		C T	:
SET			: SET			BACK :
END			: P R O G

or

To Clear program...

		DT STA		R T	ST O P	CH	SPD	Press ADD/DLT.
		----: ----: -- -- --
		8 10 : 00P			12 : 00P	02	SP
	10		8: 00P		9: 00P	10	SP
		S U	9: 00P		10 : 00P	L1	LP
		C AN C EL		: A DD / DLT
		SELECT		1-8 :
		ENTER		: SET
		EXIT		: PROG
4	Press		PROG
	to end		the		programming.

Notes

•If you are using a Cable Box, the VCR’s channel for Timer Recording must be set to the Cable Box input channel and Cable Box must be manually set to the desired channel. Cable Box power must be left on.

•2 minutes before Timer Recording is performed, “PLEASE PREPARE FOR TIMER REC” appears and Timer Indicator flashes.

Be sure a cassette with record tab is loaded and DECK is in Stop mode.

•If a power interruption occurs while programming the timer, the timer program(s) may be

canceled. If “TIMER PROGRAMS WERE LOST DUE TO POWER INTERRUPTION” appears on-screen, please re-enter the timer programs.

•If the start time for Timer Recording comes up during recording and playing back, Timer Recording will not be performed.

Important notes when using DSS Receiver

•When recording programs via DSS Receiver, DSS Receiver must be left on.

•When recording programs via an antenna or cable, DSS Receiver must be turned off.

VCR Operation

25