Panasonic PV-D4762 operating instructions Vcr

Location of Controls (continued)

Rear View of DECK

AC Power Plug

•While plugged into an AC outlet, this DECK consumes 4 W of electrical power in off mode.

Component Video Output Connector (Y, P

p. 13

SELECT SW (DVD Only) p. 13

Bold	:	VCR	Function	Italic : DVD Function
Bold Italic		: VCR	and DVD Functions

VHF/UHF Antenna Output Terminal p.12

VHF/UHF Antenna Input Terminal p. 12

B, P R ) (DVD Only)

Video Output	Video Input
Connector	Connector
p. 12	p. 39

DVD	OUTPUT	COMPONENT				OUT IN1
		VIDEO OUT					IN FROM ANT.
DIGITAL	SEE MANUAL	Y		OUT	VIDEO
AUDIO OUT
(PCM/BITSTREAM)		P	B	L	L		VHF/UHF
OPTICAL	S-VIDEO OUT
				AUDIO2	AUDIO1		OUT TO TV
		SELECT P	R	• R	R	•

Optical	Digital Audio	S-Video Out	Audio Output 2		Audio Input
Output	Connector	Connector	Connector (L/R)		Connector (L/R)
(DVD Only)		(DVD Only)	p. 13	Audio Output 1	p. 39
p. 15		pp. 10, 13
				Connector (L/R)
				p. 12

The following table shows the status of the output jacks when in VCR or DVD mode.

		Video Output			Component			S-VIDEO OUT
		Audio Out 1
					Video	Output
		Audio Out 2
	VCR	YES				N/A		N/A
	DVD	YES		YES		➛SELECT SW		(Switchable)	➛YES
Note	•	PROG functions on the remote are not available when		using Component Video Output
		and S-VIDEO OUT. Please set TV to either RF INPUT or VIDEO INPUT, and then press
		PROG.
To enjoy PROGRESSIVE SCAN video
(1). Connect		Component Video Output	to the component		video input terminals of a television.
	(See p. 13.)
(2). Set the “COMPONENT VIDEO OUT”/“S-VIDEO OUT”						SELECT	SWITCH	, in the back of the
	DECK, to “COMPONENT VIDEO OUT.” (See above.)
(3).When the PROGRESSIVE button is pressed, the ON lamp lights up (see p. 9) and the
	PROGRESSIVE SCAN signal is output from		the			Component Video	Output	Connector	.

Note

•The PROGRESSIVE button can be operated when the DECK is in DVD function mode.

•The screen may shift off-center when using progressive output. Please adjust the screen position if this occurs. (Refer to your TV manual.)

•The unit does not output video signals from the “VIDEO OUT” or “S-VIDEO OUT” terminals

when the ON lamp is lit.

10 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com