Panasonic PV-GS500 Magic Wire Remote Control, ª Selecting the remote control mode

Before using

ªSelecting the remote control mode

If 2 Camcorders are used simultaneously, set the mode for one pair of Camcorder and remote control to [VCR1] and that of the other pair to [VCR2]. This will prevent interference between the 2 pairs. (The default setting is [VCR1]. When the button-type battery is replaced, the setting will revert to the default [VCR1].)

1Setting on the Camcorder:

Set [SETUP] >> [REMOTE] >> [VCR1] or [VCR2].

2Setting on the remote control:

2 1

[VCR1]:

Press [D] and [∫] simultaneously. 1 [VCR2]:

Press [E] and [∫] simultaneously. 2

ªConcerning the button-type battery

≥When the button-type battery runs down, replace it with a new battery (part number: CR2025). The battery is normally expected to last about 1 year, but it depends on operation frequency.

≥Keep the button-type battery out of the reach of children.

≥If the remote control mode of the Camcorder and that of the remote control do not match with each other, “REMOTE” will appear. When the remote control is operated for the first time after the Camcorder is turned on, “CHECK REMOTE

MODE” (-73-) will appear and operation is impossible. Set the same remote control mode.

≥The remote control is intended for indoor operation. Outdoors or under strong light, the Camcorder may not operate properly even within the usable ranges.

Magic Wire Remote Control

This controller can be used from different high and low angles. It is also handy when a tripod is used. When you do not use the controller, attach the clip to the grip belt. Left-handed users can use this Camcorder more easily.

(1)

(2)

(3)

(1)Recording start/stop button [REC]

(2)Zoom lever [W/T]

(3)Photoshot button [PHOTO SHOT]

ªConnect the Magic Wire Remote

Control to the Camcorder

1Plug the Magic Wire Remote Control into the [REMOTE/MIC] terminal as far as it goes.

REMOTE/MIC

ªAbout the clip (on the backside)

When you move with the clip attached to your pocket or elsewhere, beware of knocking over the tripod and causing the Camcorder to fall off the table.

≥The [PHOTO SHOT] button on the Magic Wire Remote Control cannot be pressed halfway.

≥If the pin plug of the control is not inserted

securely into the [REMOTE/MIC] terminal as far as it will go, normal operation may not be ensured.

≥Before using, make sure that the plug is inserted securely into the terminal as far as it will go.

29

LSQT0975