Panasonic SA-XR59 other equipment ENGLISH, Connecting the antennas and AC mains lead, other cords

•Turn off all components before making any connections.

•Peripheral equipment and cables sold separately unless otherwise indicated.

•To connect equipment, refer to the appropriate operating instructions.

Connecting the antennas and AC mains lead

Adhesive tape

FM indoor antenna (included) Fix the other end of the antenna where reception is best.

1

LOOP EXT	LOOP ANT
	GND

	FM ANT	AM ANT
	DIGITAL IN
(TV/STB) (DVD RECORDER) (BD/DVDPLAYER)		(CD)

OPTICAL1 OPTICAL2 COAXIAL1 COAXIAL2

2						AM loop antenna (included)
						Keep the antenna cord away from
						DVD recorders, DVD players, and
			2			other cords.
	1
								SURROUND		SURROUND BACK
			3					R	L	R	L
OUT			(DVD RECORDER) IN
	S VIDEO			Black VIDEO
						Red
OUT	BD/ IN	IN	IN	OUT	IN	IN	IN	IN
TV MONITOR DVD PLAYER DVD RECORDER TV/STB				TV MONITOR DVD		DVD RECORDER	VCR	TV/STB
			CENTER
	L
	R

IN	SUBWOOFER SURROUND FRONT	IN	IN	IN	OUT
CD	DVD/DVD 6CHWhiteIN DVD RECORDER		VCR	TV/STB	SUBWOOFER

AUDIO

other equipment ENGLISH

FM outdoor antenna (not included)		To connect a 75 Ω coaxial cable
•	Disconnect the FM indoor antenna.	1	Remove a piece	3	Remove the lead wire and
•	The antenna should be installed by a		of the outer vinyl		clamp it with the plastic
	competent technician.		insulator.		bar.

AC mains lead (included)

To household mains socket

Connecting

Two types of wire commonly used for connection from the antenna are 300 Ω parallel feeder wire and 75 Ω coaxial cable. For best resistance to interference, use 75 Ω coaxial cable.

10 mm

7 mm

2Carefully pull the tabs apart to remove the cover.

Lead wire

Plastic bar

Insertion of connector Even when the connector is perfectly inserted, depending on the type of inlet used, the front part of the connector may jut out as shown in the drawing. However there is no

FM outdoor antenna

FM ANT

or

300 Ω feeder wire

75 Ω coaxial cable

Antenna plug adapter (included)

4Install the coaxial cable. Clamp the cable conductor, and wind it on so that it does not contact anything else.

Clamp with pliers.

5 Attach the cover.

To connect a 300 Ω feeder wire

Loosen the screws, connect the wires, and tighten the screws to secure the connection.

problem using the unit.

Appliance inlet

Connector

Approx. 6 mm

Connect AC mains lead after all other cables and cords are connected.

•The included AC mains lead is for use with this unit only. Do not use it with other equipment.

•Do not use an AC mains lead from other equipment.

•If the unit is left unplugged for longer than two weeks, all settings will revert to the factory settings. Perform the settings again if this occurs.

Using headphones

VOLUME

SPEAKERS

AB

AUTO	ADVANCED			HDMI
SPEAKER SETUP	DUAL AMP	BI-AMP
				INPUT SELECTOR	VOLUME
SPEAKERS		TUNE	MENU		ENTER
A	B	SURROUND	SETUP

1.Press [SPEAKERS A] and [SPEAKERS B] to turn off the speakers.

2.Reduce the volume and connect the headphones.

Plug type: 6.3 mm stereo (in diameter)

3.Adjust the volume.

Note

•	Avoid listening for prolonged periods of time to prevent hearing
	damage.
•	Turning the speakers off automatically engages stereo play, and
	when you play multi-channel sources they are down-mixed (2CH
	MIX). (Some DVD-Audio prohibit down-mixing.)

AUTO DETECTOR

RETURN

AUX SETUP MIC

S VIDEO IN VIDEO IN L AUDIO IN R

(Headphone jack)

• Note that if you are using DVD 6CH input (➡ page 20), the input

source switches to “DVD” (2 channel) and only the sound for the

front speakers is output.	RQTV0247
	11