Panasonic SC-AK350, SC-AK250 Preparing the remote control, DEMO function, Français Lang - Lang

Optional antenna connections

Use outdoor antenna if radio reception is poor.

Note:

Disconnect the outdoor antenna when the unit is not in use. Do not use the outdoor antenna during a lightning storm.

FM outdoor antenna

(

Rear panel of this unit

AM outdoor antenna

Rear panel

of this unit FM outdoor antenna

(not included)

75 Ω coaxial cable (not included)

AM outdoor antenna (not included)

5-12 m

AM loop antenna (included)

DEUTSCH

DANSK

•	Disconnect the FM indoor antenna.	•	Run a piece of vinyl wire horizontally across a window or
•	The antenna should be installed by a competent		other convenient location.
	technician.	•	Leave the loop antenna connected.

Preparing the remote control

AA/R6/LR6

DEMO function

■Batteries

• Insert so the poles (+ and –) match those in the remote control.

• Remove if the remote control is not going to be used for a long period of time. Store in a cool, dark place.

• Replace if the unit does not respond to the remote control even when held close to the front panel.

• Do not use rechargeable type batteries.

• Mishandling of batteries in the remote control can cause electrolyte leakage, which may cause a fi re.

• If electrolyte leaks from the batteries, consult your dealer.

Wash thoroughly with water if electrolyte comes in contact with any part of your body.

Do not:

•mix old and new batteries.

•use different types of batteries at the same time.

•heat or expose batteries to fl ame.

•take apart or short circuit the batteries.

•attempt to recharge alkaline or manganese batteries.

•use batteries if the covering has been peeled off.

• put heavy objects on the remote control.

• spill liquids onto the remote control.

■Use

Aim at the remote control sensor, avoiding obstacles, at a maximum range of 7 m directly in front of the unit.

Refer to page 8 for the remote control sensor position.

When the unit is fi rst plugged in, a demonstration of its functions may be shown on the display.

If the demo setting is off, you can show a demonstration by selecting “DEMO ON”.

FRANÇAIS

LANG - 4

LANG - 5

-	Press and hold [7, STOP, –DEMO].
	+
	The display changes each time the button is held down.
	NO DEMO (off) Ô DEMO ON (on)

While in standby mode, select “NO DEMO” to reduce power consumption.

7, STOP, –DEMO Note:

DEMO function cannot be turned on when Dimmer is on.

RQTV0196

7

RQT8043

RQTV0196-B.indd 7 2/23/07 4:48:58 PM