Panasonic SC-BTT490 owner manual On the unit’s display

Models: SC-BTT490

1 56
Download 56 pages 47.56 Kb
Page 48
Image 48
On the unit’s display

On the unit’s display

F99

¾The unit fails to operate properly. Press [Í/I] on the main unit for 3 seconds to switch the unit to standby, then switch back on.

HDMI ONLY

¾Some BD-Video discs can only be output with HDMI.

NET

¾While connecting to a network.

No PLAY

¾There is a viewing restriction on a BD-Video or DVD-Video. (> 39)

No READ

¾The media is dirty or badly scratched. The unit cannot play.

PLEASE WAIT

¾The unit is carrying out an internal process. This is not a malfunction. You cannot operate the unit while “PLEASE WAIT” is displayed.

REMOVE

¾The USB device is drawing too much power. Remove the USB device.

SET (“ ” stands for a number.)

¾The remote control and main unit are using different codes. Change the code on the remote control.

Press and hold [OK] and the indicated number button at the same time for more than 5 seconds.

U59

¾The unit is hot.

The unit switches to standby for safety reasons. Wait for about 30 minutes until the message disappears.

Select a position with good ventilation when installing the unit.

Hor F

(“ ” stands for a number.)

¾Check and correct the speaker cable connections.

¾There is something unusual.

¾Check the unit using the troubleshooting guide. If the service number remains displayed, do the following.

1Disconnect the plug from the AC outlet, wait a few seconds, then reconnect it.

2Press [Í/I] to turn the power on.

If the service number remains displayed despite doing the above, request service from the dealer. Inform the dealer of the service number when requesting service.

IPOD OVER CURRENT ERROR

¾The iPod/iPhone is drawing too much power. Remove the iPod/iPhone, and turn the unit off and on again.

START

¾The system is being restarted during the firmware update. Please do not turn off the unit.

UPD/

(“ ” stands for a number.)

¾The firmware is being updated. Please do not turn off the unit.

FINISH

¾The firmware update is complete.

NOT CONDITIONAL

¾The requested operation cannot be conducted.

SET OK

¾The stations are set, and the radio tunes to the last preset station.

ERROR

¾Automatic presetting is unsuccessful. Preset the stations manually.

TUNED/STEREO

¾Stereo broadcasting or stereo sound is selected.

TUNED

¾Monaural broadcasting or monaural sound is selected.

48 VQT3X49

Page 48
Image 48
Panasonic SC-BTT490 owner manual On the unit’s display