Panasonic SC-DK20 Antennas and AC power supply cord, Set the voltage before connection below

VOLT ADJ

If the power supply in your area is 115 V or 120 V, please set the voltage selec- tor as follows.

For 115 V: Set to 110 V.

For 120 V: Set to 127 V.

Note that the unit will be seriously damaged or fail to operate correctly if this setting is not made correctly.

220 I V

230

STEP3 Antennas and AC power supply cord

For areas except U.S.A., Canada, Australia and N.Z.

FM indoor antenna

Twist the vinyl tip and pull off.

Fix the other end of the antenna where reception is best.

Adhesive tape

Set the voltage before connection (➡ below).

AC power supply cord

For areas except U.S.A., Canada, Australia, N.Z. and Asia

If the power plug will not fit your socket, use the power plug adap- tor (included).

Note

The included AC power supply cord is for use with this unit only. Do not use it with other equipment.

Conserving power

The unit consumes power even when it is turned off with [POWER f/I] ([f/I]). To save power when the unit is not to be used for a long time, unplug it from the household AC outlet. Remember to reset the radio stations and any other memory items before using the unit again.

U.S.A. and Canada: 0.25 W

Australia and N.Z.: 0.6 W

Others: 0.8 W

For your reference

Information you enter into the unit’s memory, except for time, re- mains intact for up to a week after the AC power supply cord is disconnected.

To household

AC outlet

Simple set-up

AM loop antenna

Twist the vinyl tip and pull off.

Stand the antenna up on its base.

Keep loose antenna cord away from other wires and cords.

Voltage setting

For areas except U.S.A., Canada, Australia and N.Z.

Use a flat-head screwdriver to turn the voltage selector to the appropriate posi- tion for your area.

127 V↔ 110 V↔ 220 V-230 V↔ 240 V

9

RQT6345