Panasonic SC-HT441W manual Accessor es, If you see this symbol, Corporation of North America

HT441WEn.bookPage40Friday,June9,20065:43PM			6	4	2
Accessor es
Please check and identify the supplied accessories. Use numbers indicated in parentheses when asking for replacement parts.
(Product numbers correct as of June 2006. These may be subject to change.)
To o der accessories, refer to “Accessory Purchases” on page 38.
∏ Remote control	∏ 1 Video cable	∏ 1 FM indoor antenna	∏ 2 Sheets of speaker cable
(N2QAYZ0000 1)	(K2KA2BA00001)	(RSA0007-L)	stickers
			6	4	2
			WOOFER	Rch	Rch
			SUB	SURROUND FRONT
			SUB	SURROUND FRONT
			WOOFER	Rch	Rch

∏ 2 Remote control batteries	∏ 1 AM loop antenna	∏ 2 AC power supply cords
	(N1DAAAA00002)	(K2CB2CB00018)

5	3	1
CENTER	Lch	Lch
	SURROUND	FRONT
CENTER	SURROUND	FRONT
	Lch	Lch
5	3	1

FCC Note:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

≥Reorient or relocate the receiving antenna.

≥Increase the separation between the equipment and receiver.

≥Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

≥Consult the dealer or an experienced radio/TV technician for help.

FCC caution: To maintain compliance with FCC regulations, shielded interface cables must be used with this equipment. Operation with non-approved equipment or unshielded cables may result in interference to radio and TV reception. Any changes or modifications not approved by the party responsible for compliance could void the user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and

(2)this device must accept any interference received, including interference that may cause undesired operation.

Responsible Party:

Panasonic Corporation of North America

One Panasonic Way

Secaucus, NJ 07094

Telephone No.: 1-800-211-7262

WARNING:

To satisfy FCC RF exposure requirements for mobile transmitting devices, a separation distance of 20 cm or more should be maintained between the antenna of this device and persons during device operation. To ensure compliance, operations at closer than this distance is not recommended. The antenna used for this transmitter must not be co-located in conjunction with any other antenna or transmitter.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference,

(2)This device must accept any interference received, including interference that may cause undesired operation.

-If you see this symbol-

Information on Disposal in other Countries outside the European Union

This symbol is only valid in the European Union. If you wish to discard this product, please contact your local authorities or dealer and ask for the correct method of disposal.

(Inside of product)

Panasonic Consumer Electronics	Panasonic Puerto Rico, Inc.
Company, Division of Panasonic	Ave. 65 de Infantería, Km. 9.5
Corporation of North America	San Gabriel Industrial Park, Carolina,
One Panasonic Way Secaucus,	Puerto Rico 00985
New Jersey 07094

http://www.panasonic.com

C2006 Matsushita Electric Industrial Co., Ltd.

p

RQT8779-P

Printed in Malaysia F0606KN0