Panasonic SC-HT441W Using an outdoor antenna optional, FM outdoor antenna, Radio, Main unit only

∫HT441WEnFM frequency.bookPage27Friday,Junestep 9,20065:43PM

Main unit only

The step is factory-set to 0.2-MHz, but you can change it to receive broadcasts allocated in 0.1-MHz steps.

Press [SELECTOR] to select “FM”.

2 Press and hold [SELECTOR].

After a few seconds the display changes to show the current minimum frequency. Continue to hold the button down. The minimum frequency changes and the step is changed.

To return to the original step, repeat steps 1 and 2.

[Note]

After changing the setting, previously preset frequencies will be cleared. Preset them again.

Using an outdoor antenna (optional)

Use outdoor antennas if radio reception is poor.

≥Disconnect the antenna when the unit is not in use.

≥Do not use the outdoor antenna during an electrical storm.

FM outdoor antenna	Leave the AM loop antenna connected.
[Using a television antenna (not included)]

Radio

≥Disconnect the FM indoor antenna.

≥The antenna should be installed by a competent technician. Rework your outdoor antenna’s 75 ≠ coaxial cable as follows.

	LOOP
	ANT GND
	FM ANT
75 ≠ coaxial cable	75
	LOOP
(not included)

Antenna plug	AM
	ANT
(not included)	EXT

AM outdoor antenna

[Using a vinyl wire (not included)]

Run a piece of vinyl wire horizontally across a window or other convenient location.

5 to 12 m

(16 to 39 feet)

Using the AM/FM

1 Remove a piece of the outer		2 Carefully pull the tabs		3 Install the coaxial cable.	4 Attach the cover.
vinyl insulator.		apart to remove the cover.		Clamp the cable conductor, and
				wind it on so that it does not
				contact anything else.
	10 mm (13/32z)
			2
10 mm (13/32z)	Peel back	1	1
				Clamp with pliers
7 mm (9/32z)

RQT8779

27