SVAT Electronics 2CV500 - 4CH Things To Consider Before Installation, Camera Installation, Wiring

THINGS TO CONSIDER BEFORE INSTALLATION

CAMERA INSTALLATION

•The camera should be installed between 8 and 13ft above the area to be monitored

•Ensure there are no obstructions in the camera’s view, to maximize viewing area

•Ensure that the sunshade is positioned to avoid glare and position camera away from direct sunlight or indoor lighting

•Decide whether the camera will be wall-mounted, ceiling mounted or sit on a desk/table top. If you are mounting the camera on a wall or

ceiling, use the mounting hardware in the package. We recommend that the mounting bracket is secured using the included screws for all installations

•This camera comes with 60ft of video/power wire. Please make sure that you mount the cameras no more than 60ft from the TV/monitor/ VCR/DVR. If longer wiring distance is required, 60 ft extensions can be purchased (CVW62) from your local reseller or at www.SVAT.com

•We recommend using a surge protected power bar to protect the cameras internal circuitry

MOUNTING

1.Decide if the camera will be wall-mounted or sit on a desk/tabletop. The camera can be adjusted for either mounting scenario by rotating it to the required position.

2.Screw the mounting bracket into the camera’s mounting hole, turning it clockwise.

3.Mount the camera in the desired location no more than 60 ft from the DVR unless you have purchased additional wiring. You may wall, ceiling or desk mount these cameras.

4.Adjust cameras to the desired viewing angles.

WIRING

1.Plug the 4 PIN DIN female connection on the camera into the 4 PIN DIN male connection on the 60ft video/power wire.

3.Plug the camera’s power adapter into an AC outlet.

2.Plug the included four port power supply into the camera power adapter then into the red power jack located on the 60 ft video/ power wire.

4.Attach the BNC to RCA connectors to one of the video inputs on the back of the DVR.

CV500 - 4CH 12