SVAT Electronics 2CV500 - 4CH Display, To Set Dwell Time, To Enter Auto Switch Mode

MAIN MENU...continued

DISPLAY

You can choose whether or not to display any individual camera. By setting the display to OFF the camera will not be displayed in live viewing, however the camera channel will continue to record as per the defined recording settings. The video will be displayed during playback.

DWELL TIME

Dwell time refers to the amount of time the footage from a particular camera will be displayed for when you’re in auto sequence mode. You can set the dwell time for each camera individually. The auto sequence mode can dwell on one camera from 0-99 seconds.

To Set Dwell Time:

1.Highlight the camera you wish to setup.

2.Highlight dwell time.

3.Use the mouse wheel or directional arrows to set the time (in seconds) that each particular camera will stay on the screen when in auto sequence mode.

4.Repeat steps 1-3 for each camera.

5.Press Menu or Click to save settings and return to the Main Menu. Exit the Main Menu . The DVR will take a few moments to load the settings.

To Enter Auto Switch Mode:

1.Scroll mouse to the bottom of the screen to reveal the pop up Menu.

2.Click the auto sequence icon.

The DVR will begin automatically switching between the active cameras according to your dwell time settings.

PTZ SETUP

This DVR supports Pan, Tilt, Zoom (PTZ) or “Dome” cameras, which are not included.

The PTZ camera must use RS-485 and one of the supported protocols (See Specifications). For instructions on setting up your PTZ cameras please refer to the instruction manual for the PTZ camera or contact the PTZ camera manufacturer.

Left-Right Speed:Controls the speed at which the DVR will move the PTZ camera horizontally:"#"is the slowest speed and "# # # # # #" is the fastest.

Up-Down Speed: Controls the speed at which the DVR will move the PTZ camera vertically: "#" is the slowest speed and "# # # # # #" is the fastest.

Auto Speed: Can be used if the PTZ supports preset positions. Auto-speed will control the speed which the camera will move through the preset positions.

Baud Rate: This is a camera specific setting defined by the manufacturer. Please consult your PTZ camera manual or manufacturer for details on this setting.

Protocol: This is a camera specific setting defined by the manufacturer. Please consult your PTZ camera manual or manufacturer for details on this setting. Supported protocols can be found in the specifications.

CV500 - 4CH 19