Connect the speaker cables.
≥To make sure that the speaker cable is connected to the correct speaker, match the colour of the speaker connector with the colour of the L/R indicator on the speaker label so as not to connect the speaker cable to the wrong speaker.
≥Insert the wire fully, taking care not to insert beyond the wire insulation.
1 Insert the wire fully.
r: White
s: Blue line
2 Press into the
groove. Push
Drive a screw (not supplied) into the wall.
≥Use the measurements indicated below to identify the screwing positions on the wall.
≥Leave at least 20 mm of space above and each side of the speaker to allow enough space for fitting the speaker.
≥The position in the wall where the screw is to be attached as well as the screw should be capable of supporting over 33 kg.
≥Keep the screws out of reach of children to prevent swallowing.
A At least 30 mm
B ‰4.0 mm
C ‰7.0 mm to ‰9.4 mm
D Wall or pillar
E 5.5 mm to 6.5 mm
Getting started
F 211 mm | G 388 mm | H 201 mm | I 14.3 mm |
Fit the speaker securely onto the screw(s) with the hole(s).
DO | DO NOT |
≥ Move the speaker so | ≥ In this position, the |
that the screw is in | speaker will likely fall |
this position. | if moved to the left or |
| right. |
11
VQT3R83