Advanced operations
The following settings are unnecessary under general usage conditions of the system.
∫Changing the dual audio
Change the dual audio from main to secondary.
1Confirm the digital audio output setting on the
connected TV or player, etc. is set to “Bitstream”.
2Press and hold [HDMI 1/2] for more than 2 sec.
3 While the indicator of the current setting is flashing, press [HDMI 1/2] to change the setting.
A : Main
B : Secondary
A, B : Main and secondary
≥The setting works only when the dual audio is available in the audio source.
≥The setting is maintained until it is changed again.
≥The same setting is used for [TV] and [HDMI 1/2] audio sources.
∫Remote control code
When other Panasonic devices respond to this system’s remote control, change the remote control code on the active subwoofer and the remote control.
Preparation
≥Turn off all other Panasonic products.
≥Turn on this system.
Change the remote control code to code 2:
1Aim the remote control at this system’s remote control sensor.
2Press and hold [MUTE] and [HDMI 1/2] on the remote control for more than 4 sec.
≥All the indicators will blink for 10 sec when the code of this system is changed.
≥The setting is maintained until it is changed again.
≥If this system does not operate after changing the code,
repeat steps 1 and 2.
≥To change the remote control code to code 1, repeat the steps above, but replace [HDMI 1/2] with [TV].
∫To turn off the 3D surround effect and
clear-mode dialog effect
Depending on your preference, it is possible to use only the Dolby Virtual Speaker effect by turning off the 3D surround effect and the
1Press and hold [TV] for more than 2 sec.
≥The indicator for the current setting blinks for 10 sec. Only Dolby Virtual Speaker is on.
3D surround effect and
2While the indicator is blinking press [TV] to
change the setting.
≥The setting changes each time [TV] is pressed.
≥The setting will be reset to on when this system is turned off.
∫To turn off VIERA Link “HDAVI Control”
When “HDAVI Control” compatible equipment does not work well with this system, for example, it is possible to turn off this function as follows:
≥When VIERA Link is turned off the ARC function is not available. Be sure to connect the optical digital audio cable. (> 19)
1Press and hold [MUTE] on the remote control and [s VOL] on the active subwoofer for more
than 2 sec.
2After the setting has changed, turn off all the connected devices and then turn them on again.
∫To reduce the clear-mode dialog effect
When the dialog does not sound natural while the |
| |
| ||
volume is set low, for example, it is possible to |
| |
reduce the dialog enhancing effect as follows: | Operations | |
∫ To turn off the volume limitation | ||
Press and hold [TV] on the remote control and |
| |
[s VOL] on the active subwoofer for more than |
| |
2 sec. |
| |
If a state of the lowered volume disturbs you every |
| |
time this system turns on, for example, it is possible |
| |
to turn off this function as follows: |
| |
Press and hold [MUTE] on the remote control and |
| |
[VOL r] on the active subwoofer for more than |
| |
2 sec. |
| |
|
|
|
The settings of VIERA Link “HDAVI Control”, the
≥All the indicators will blink once when the setting is changed.
25
VQT3R83
