Place the speakers vertically
∏ 1 Speaker (L) | ∏ 1 Speaker (R) | ∏ 2 Speaker cables |
|
| (L): WHITE |
|
| (R): RED |
≥For a safety measure to prevent the speakers from falling, refer to page 16.
≥To prevent damage or scratches, lay down a soft cloth and perform the assembly on it.
Connect the speaker cables.
≥Insert the wire fully, taking care not to insert beyond the wire insulation.
≥To make sure that the speaker cable is connected to the correct speaker, match the colour of the speaker connector with the colour of the L/R indicator on the speaker label so as not to connect the speaker cable to the wrong speaker.
Push
1 Insert the wire fully.
r: White
s: Blue line
2 Press into the groove.
Drive a screw (not supplied) into the wall.
≥Use the measurements indicated below to identify the screwing positions on the wall.
≥Leave at least 20 mm of space above and each side of the speaker to allow enough space for fitting the speaker.
≥The position in the wall where the screw is to be attached as well as the screw should be capable of supporting over 33 kg.
≥Keep the screws out of reach of children to prevent swallowing.
| | A At least 30 mm |
|
| B ‰4.0 mm |
| |
|
|
| |
|
| C ‰7.0 mm to | |
| ‰9.4 mm |
| |
|
| ||
|
| D Wall or pillar |
|
|
| E 5.5 mm to 6.5 mm |
|
|
|
| |
| |
|
|
|
|
| |
F55 mm G 24.5 mm
Fit the speaker(s) securely onto the screw(s) with the hole(s).
12
VQT3R83
DO | DO NOT |
≥ Move the speaker so | ≥ In this position, the |
that the screw is in this | speaker will likely fall if |
position. | moved to the left or |
| right. |
