1
| 3 |
STOP | 2 |
/ REW / | , |
/FF/ 
1 OPEN
Insert inside the guides
Forward side
2 TAPE 
3 VOLUME
dB |
DOWN U P
Cassette tapes
1 Press [OPEN c] insert a cassette with the tape facing in.
When the button is pressed, the unit comes on automatically. Make sure the cassette is fully inserted and close the lid by hand.
2 Press [TAPE 3] to start playback.
One side is played, then playback stops automatically. To play on the other side of the cassette, turn the
cassette over and press [TAPE 3].
3 Adjust the volume.
To stop tape playback
Press [STOP L].
One-touch play
When the system is OFF and a cassette is already inserted, play starts automatically when you press [TAPE 3].
Press [g/REW/4 ] (rewind) or [3/FF/ f]
Cassette tape selection and care
Types of cassettes which can be played correctly
Use normal position tapes.
High position and metal position tapes can be played, but the unit will not be able to do full justice to the characteristics of these cassettes.
•Tapes exceeding 100 minutes are thin and can break or get caught in the mechanism.
•Tape slack can get caught up in the mechanism and should be wound up before the tape is played.
•Endless tapes can get caught up in the deck’s moving parts if used incorrectly.
To find the beginning of a program (TPS: Tape Program Sensor)
TPS finds the beginning of a track and resumes play from there. Each press increases the number of tracks skipped, up to a maximum of 9.
Press [g/REW/ 4] or [3/FF/f] during play.
Notes
The TPS function searches for silent parts of about 4 seconds in length which are normally found between tunes. As a result, it may not function properly in the following cases:
•With short silent parts
•When noise occurs between tunes
•With silent parts found within tunes
Listening operations
15 |
RQT6682 |
