Troubleshooting guide
Before requesting service, make the below checks. If you are in doubt about some of the check points, or if the remedies indicated in the chart do not solve the problem, refer to the "Customer Services Directory" on page 27 if you reside in the U.S.A, or refer to the "Product information" on page 26 if you reside in Canada.
Common Problems
No sound.
Sound is unfixed, reversed or comes from one speaker only.
Turn the volume up.
The speaker cords may be shorted. Turn the unit off, check and correct the connections and turn the unit on. (è page 5)
Check the speaker connections. (è page 5)
| Humming heard during play. | An AC power supply cord or fluorescent light is near the cables. Keep other appliances and leads away |
|
| from this unit’s cables. |
| “ERROR” is displayed. | Incorrect operation performed. Read the instructions and try again. |
| You plugged the AC power supply cord in for the first time or there was a power failure | |
|
| recently. |
|
| Set the time. (è page 8) |
| “F61” is displayed. | Check and correct the speaker cord connections. (è page 5) |
|
| If this does not fix the problem, there is a power supply problem. Consult the dealer. |
Listening to the radio |
| |
|
|
|
| Noise is heard. | Use an outdoor antenna. (è page 6) |
| The stereo indicator flickers or |
|
| doesn’t light. |
|
| Sound is distorted. |
|
| A beat sound is heard. | Turn the TV off or separate it from the unit. |
| A low hum is heard during AM | Separate the antenna from other cables and cords. |
| broadcast. |
|
When there is a television set nearby
The picture on the TV disappears or stripes appear on the screen.
The location and orientation of the antenna are incorrect. If you are using an indoor antenna, change to an outdoor antenna. (è page 6)
The TV antenna wire is too close to the unit. Separate the antenna wire of the TV set from the unit.
Using the cassette deck
Poor quality sound. Recording is not possible.
Clean the heads.
If the erasure prevention tabs have been removed, cover the holes with adhesive tape.
Playing discs
The display is wrong or play won’t start.
The total number of tracks displayed differs each time the same disc is inserted. Unusual sound is heard.
The disc may be upside down. Wipe the disc.
Replace the disc if it is scratched, warped, or
The disc may be scratched, or its data may be defective. Replace the disc.
The disc was incompletely formatted. Use the recording equipment to fully format the disc before recording.
The unit cannot display the remaining play time for variable bit rate (VBR) tracks
“TAKE OUT/DISC” appears on the display.
There is a problem with the disc mechanism. (A power failure may have occurred.)
The tray will open automatically. Remove the disc from the tray, and after ensuring there is no disc in the tray, close it. The unit will make the disc changing noises for a few moments and then it should operate normally.
The remote control
Remote control doesn’t work.
Check that the batteries are inserted correctly. (è page 4) Replace the batteries if they are worn.
Panasonic Consumer Electronics | Panasonic Sales Company, | Panasonic Canada Inc. |
Company, Division of Matsushita | Division of Matsushita Electric of | 5770 Ambler Drive |
Electric Corporation of America | Puerto Rico, Inc. ("PSC") | Mississauga, Ontario |
One Panasonic Way Secaucus, | Ave. 65 de InfanterIa, Km. 9.5 | L4W 2T3 |
New Jersey 07094 | San Gabriel Industrial Park, Carolina, | www.panasonic.ca |
http://www.panasonic.com | Puerto Rico 00985 |
|
En
C 2004 Matsushita Electric Industrial Co., Ltd | |
Printed in Malaysia | H0104SG0 |
