Panasonic SDR-H250EB operating instructions About recovery

LSQT1211(PAL_ENG).book 95 ページ ２００７年２月１３日 火曜日 午後１時１４分

Others

CHANGE TO MANUAL
MODE.
CANCEL NIGHT VIEW	You are attempting to use a function that cannot be used
MODE.	simultaneously.
TURN OFF THE VIDEO
LIGHT.
OPERATION FAILED.
EXCESSIVE SHOCK	The unit has detected that it is being dropped so the operation has
DETECTED. PLEASE TRY	stopped.
AGAIN AFTER A WHILE.
INTERNAL TEMPERATURE	The internal temperature of this unit is high so it cannot be operated.
TOO HIGH. PLEASE TURN
	Turn off the power, wait until the temperature falls and then turn on
UNIT OFF AND WAIT A
	the power again.
WHILE.
OPERATION STOPPED.	The internal temperature of this unit is extremely low so it cannot be
	operated.
TEMPERATURE TOO LOW.	If “Please Wait.” appears after this message, wait a while without
	turning the unit off. It may take time until the unit can be used.
PUSH THE RESET	An irregularity in the unit has been detected. Remove the SD card
SWITCH.	then press the RESET button to restart the unit. (l 102)
DISCONNECT USB	The unit cannot correctly establish the connection to the computer
	or printer. Disconnect and reconnect the USB cable and then select
CABLE.
	the desired USB function again.
CANNOT OPERATE WHILE	The unit’s power cannot be turned off when the unit is connected to
USB CONNECTED.	the computer.

About recovery

It is possible that the system cannot complete writing of a file normally when, for example, power is turned off for some reason during recording or editing.

If faulty management information is found when the HDD or a card is accessed, one of the following messages may appear. Be sure to follow the messages. (Repairing may take time depending on the error.)

HDD ERROR DETECTED. NOW REPAIRING DATA.

CARD ERROR DETECTED. NOW REPAIRING DATA.

≥When you repair the data, use a battery with sufficient battery power or the AC adaptor. Even if the power is turned off without repairing the data, you can repair the data when you turn the power on again.

≥Depending on the condition of the data, it may not be possible to completely repair the data.

≥Do not repair a card that has been recorded on another device. This may cause the loss of data or the card.

95

LSQT1211