Panasonic SDR-H80 2, 3, 4

24

LSQT1484

Preparation

Setup 3Setting date and time

When the unit is turned on for the first time, a message asking you to set the date and time will appear.

Select [YES] and press the joystick. Perform steps 2 and 3 below to set the date and time.

¬Rotate the mode dial to select or .

1Select the menu. (l21)

2Select the date or time, then

adjust the desired value with the

joystick.

≥The year will change as follows:

2000, 2001, ..., 2099, 2000, ...

≥The 24-hour system is used to display the time.

≥[ ] appears on the right top of the screen

when [SET WORLD TIME] (l25) is set to

[HOME], while [ ] appears when it is set to

[DESTINATION].

3Press the joystick to enter the

selection.

≥The clock function starts at [00] seconds when

the joystick is pressed.

4Press the MENU button to finish

the setting.

≥Check the date and time displayed.

∫Changing the date and time display mode

Select the menu. (l21)

[SETUP] # [DATE/TIME] # desired display

style

∫Changing the date format

Select the menu. (l21)

[SETUP] # [DATE FORMAT] # desired

display style

≥To set summer time, select the summer time in

[HOME] for [SET WORLD TIME] after set ting

the clock.

≥The date and time function is driven by a built-

in lithium battery.

≥If the time display is [- -], the built-in lithium

battery needs to be charged. Use the following

steps to charge the battery, and then set the

date and time.

To recharge the built-in lithium battery

Connect the AC adaptor or insert the battery to

the unit, and the built-in lithium battery will be

recharged. Leave the unit as it is for approx.

24 hours and the battery will save the date and

time for approx. 6 months. (Even if the mode

dial is set to OFF, the battery is still being

recharged.)

[BASIC] # [CLOCK SET] # [YES]

[DATE] [D/T] [OFF]

15.11.2009 15.11.2009 12:34

Display style Screen display

[Y/M/D] 2009.11.15

[M/D/Y] 11.15.2009

[D/M/Y] 15.11.2009

WARNING

THE LITHIUM BATTERY IN THIS UNIT MUS T

ONLY BE REPLACED BY QUALIFIED

PERSONNEL. IF THIS IS NECESSARY,

CONTACT THE PANASONIC CUSTOMER

CARE CENTRE ON 132600 FOR YOUR

NEAREST AUTHORIZED SERVICE CENTRE.

SDR-H90&80GN-LSQT1484_mst.book 24 ページ２００８年１２月１９日　金曜日　午後４時８分

Contents

Main Information for Your Safety WARNING: CAUTION! content Carefully observe copyright laws Cards that you can use with this unit For the purposes of these operating instructions Licenses Contents Preparation Before using Setup Recording With a PC Before using Setup Using software Using a Macintosh Accessories Optional accessories handling 8 6 15 7910 11 12 13 14 Joystick 16 17 18 19 Attaching the lens cap (Included in the Filter Kit (VW-LF37WE; optional)) Lens cover Tripod receptacle About batteries that you can use with this unit 1 2 Charging the battery Charging lamp [CHARGE] A Push the battery against the battery holder and slide it until it clicks. Inserting the battery Removing the battery Warnin g Charging time and recordable time 1 adaptor and the AC outlet. 3 2 adaptor. Page About SD cards About SD cards that you can use for motion picture recording SD card handling Do not cause any vibrations or impacts to this unit Do not drop this unit Take note of the temperature of this unit HDD handling Indemnity about recorded content Access lamp card 1 2 3 4 Selecting a mode While pressing the lock release button, set the mode dial to , , or to turn on the power. To tu rn on To tu rn off How to turn the power on and off with the LCD monitor 1 2 3 4 1 select [LANGUAGE] and press Menu list Motion picture recording menus Language selection Still picture recording menus Motion picture playback menus Still picture playback menus 2 adjust the desired value with the 3 selection. 4 2 Select [HOME] and press the 3 Select your home region and enter the selection with the 4 2 the settings with the joystick. Adjusting the brightness and colour level Increasing and decreasing the brightness of the entire LCD monitor Basic camera positioning Intelligent auto mode Intelligent auto button When the intelligent auto mode is set to off 1 and open the LCD monitor. SP R 12h45mR 12h45mR 12h45m 2 1 WEB MODE 2 button to start recording. Audio recording modes Recording modes and recordable time 1 and open the LCD monitor. 0.2 R 12345R 12345R 12345 2 Number of pixels Move the zoom lever. Zoom in/out function Digital zoom function Rotate the LCD monitor tow ards the lens side. 2 mode dial is set to or . 3 To use the zoom microphone function Recording yourself Optical image stabilizer function operation icons 1 2 To cancel the function ENTER Operation icons Picture recording mode Backlight compensation Fade Help mode Select the desired icon with the joystick to display an explanation on the screen. Colour night view Soft skin mode PRE-REC Press the recording start/stop button to start recording. Self-timer This is for recording still pictures using the timer. Use this Page menus Menus Aspect ratio/Wind noise reduction/Guideline/Auto slow shutter Aspect ratio Wind noise reduction function Page Press the MANUAL AF/MF button. 2 1 (l45) 2 Scene mode Manual focus adjustment 2 3 with the joystick. 1 fill the screen with a white subject. 2 3 OPENOPEN Manual shutter speed/ aperture adjustment 1/1001001/100 OPEN 1 2 3 4 1 2 1 2 1 2 3 1 2 3 1 2 3 4 Changing the interval of playback for the slide show 1 2 3 Deleting scenes/files one at a time Deleting multiple scenes/ files 4 Press the button. 5 Select [YES], then press the Deleting the copied scenes collectively Page 2 3 4 back the part to be deleted. 6 1 2 Creating a new playlist 3 4 5 1 2 Editing a playlist 3 2 DPOF setting Select [SD CARD] in [MEDIA SELECT]. [PHOTO SETUP] # [DPOF SET] # [SET] 2 3 2 3 4 5 6 Page management Select [HDD] in [MEDIA SELECT]. Select [SD CARD] in [MEDIA SELECT]. Formatting HDD Displaying HDD information 1 2 mode dial to select or . 3 the menu. (l21) 4 Page The different copying functions available when this unit is connected to the DVD burner Device capable of copying images to discs by connecting to this unit About discs that can be used 1 2 3 4 5 Connecting this unit to the DVD burner Connect this unit to the DVD burner. (l70) 1 procedures. 1 procedures. 2 DVD COPY function 1 Copying all the scenes to discs 1 2 3 4 FAVOURITESCENES function 3 Selecting the scenes to copy to 1 disc 1 2 3 4 5 About the time it takes to copy Notes for copying data to discs using the DVD burner Page 1 device. mode dial to select . 2 3 1 2 3 4 5 7 [PAPER SIZE], then press the 8 [PAGE LAYOUT], then press the 9 Page With a PC VideoCam Suit e 2.0 SD card reader function (mass storage) End User License Agreement 1 Installing VideoCam Suite 2 3 4 5 8 1 2 1 Uninstalling the software 1 About the PC display 2 or [SD CARD] then press the Drive icons 1 task tray. 2 Device] and click [Stop]. 3 1 2 DVD COPY function Reading the operating instructions of the software Turn on this unit, then rotate the mode dial to select . 1 to upload recorded with the menu. (l21) 2 3 Upload to YouTube 1 2 3 4 Recording indications Playback indications Indications when other products are connected Confirmatory indications Page About recovery used simultaneously Page Page Page Page Page Cautions for use About this unit About the battery Causes of condensation About condensation About the AC adaptor LCD monitor Explanation of terms Automatic white balance White balance adjustment Auto focus Page Specifications SD Card/Hard Disk Video Camera Page Page Number of recordable pictures