29
LSQT1484
Recording
Recording (Basic) 2Recording motion pictures
[HDD] [SD]
Open the lens cover before turning the unit on.
1Rotate the mode dial to select

and open the LCD monitor.

2Select the recording destination

by the menu. (l21)

3Press the recording start/stop

button to start recording.

To end the recording
Press the recording start/stop button again.
[¥] and [;] are red during recording. Do not
move this unit until [;] is green.
The images recorded between pressing the
recording start/stop button to start recording
and pressing it again to pause recording
become one scene.
The scene is automatically divided when the
recorded data exceeds 3.9 GB. (The recording
will continue.)
When about 5 minutes have passed without
any operation in recording pause, the unit
automatically turns off to save battery life.
To use the unit, turn it on again.
This economy feature can also be set to [OFF].
(l22, [ECONOMY])

Screen indications

ARecording mode
BSelected recording destination
CRemaining time left for recording
When the remaining time is less than
1 minute, [R 0h00m] flashes red.
DRecording time elapsed
Each time the unit enters the recording
pause mode, the counter display will be reset
to “0h00m00s”.
While motion picture recording is in progress,
the recording will not stop even if the LCD
monitor is closed.
Do not disconnect the AC adaptor or remove
the battery if the unit is in recording mode. This
may cause a repair message to appear when
powered up again. (l94, About recovery)
[MEDIA SELECT] # [HDD] or
[SD CARD]
R 12h45mR 12h45mR 12h45m
0h00m10s0h00m10s0h00m10s

SP

SDR-H90&80GN-LSQT1484_mst.book 29 ページ 2008年12月19日 金曜日 午後4時8分