Setup 1 Charging

Insert the battery into the unit and charge it.

1 Set the mode dial to [OFF].

The unit runs on AC power (status indicator lit red) and the battery cannot be charged when the mode dial is set to any position other than [OFF].

2 Opendoor. the card/battery

Open the door by sliding the card/ battery door lever to the “OPEN” position.

3 Insert the battery.

Ensure that battery is oriented correctly, and push it into the compartment in the direction of the [▲] until it snaps into place and it is locked by the lever.

(To remove the battery, press the lever in the direction of the [ ].)

4 Closedoor. the card/battery

Close the card/battery door and slide the card/battery door lever to the “LOCK” position.

5 Connect the AC adaptor (supplied).

Connect the AC cable to the AC adaptor and then to an AC outlet.

To AC outlet

Lever

AC adaptor

AC cable＊

Small gap here.

＊Do not use the AC cable and AC adaptor of this unit with other devices. Also, do not use the AC cables and AC adaptors of other devices with this unit.

20 VQT1R00

Page 19 Page 21
Page 20
Image 20
Panasonic SDR-S7P/PC Setup 1 Charging, Set the mode dial to OFF, Insert the battery into the unit and charge it
Page 19 Page 21
Top Page Image Contents