7
Inserting a Card
1Slide the Card Slot Cover 1, and flip it to open.
≥Turn off the SD Multi AV Device, when inserting a Card.
2Hold the Memory Card placing the cut off corner 2 at the
left and showing the label 3 frontward, and then insert it
fully until it clicks.
3After the Memory Card is set, close the Card Slot Cover
1.

ªRemoving the Card

Open the Card Slot Cover and push the top of the Card. The Card
will pop up a little and allow you to pick it up with your fingers to
remove.
≥While the Card Access Lamp 4 is on, the following operations should
not be attempted: (Such action will damage the Card, cause loss of
recorded data and cause the SD Multi AV Device to malfunction.)
-Open the Card Slot Cover.
-Remove or insert the Card.
-Operate your SD Multi AV Device.
-Remove the battery or unplug the power cable.
-Apply vibration or shock.
≥Only an SD Memory card or MultiMediaCard can be used for this SD
Multi AV Device.
≥Do not touch the terminals on the back of the Card with your fingers.
≥If the Card Slot Cover is not closed completely, remove the Memory
Card and re-insert it.
≥Electrical noise, static electricity or failure of the SD Multi AV Device or
the card may damage the card or erase the data stored on the card. It
is recommended to save important data onto a personal computer.
Using the LCD Monitor
Record and play the video image while viewing the LCD Monitor.
1Put your finger on the protrusion 1 to open the LCD
Monitor.
2Adjust the LCD Monitor angle according to the desired
recording/playing angle .
≥The LCD Monitor can rotate a maximum of 180° 2 from the
vertical position to the upward direction and a maximum of 90° 3
to the downward direction. Forcefully rotating the LCD Monitor
beyond these ranges will damage the SD Multi AV Device.
≥The picture will be displayed upside down at some playing angles. If
[UPSIDE-DOWN] is selected for [LCD MONITOR] under the [OTHER
FUNCTIONS] menu the picture will be displayed upside down.
2
3
4
1
3
2
Removing the Card
Inserting a Card
OPEN
1
2
1
23
4