TUNING MENU
MANUAL TUNE
Before MANUAL TUNE, set the “CH SELECT” and “SYS SELECT”. Follow the step on page 15 to display the TUNING MENU screen.
1 | Press to select MANUAL TUNE. |
Press to access MANUAL TUNE.
2 | Press to select the desired Programme Number. |
Press to search the higher or lower channel.
STR
3
When the desired station is found, press to store. The programme position will flash.
TV/AV
Press at any time to go back to watching TV.
TUNING MENU 
CH SELECT |
| DIRECT |
SYS SELECT |
| ASIA/M. EAST |
AUTO TUNE |
|
|
MANUAL TUNE |
| ACCESS |
SOUND SYS |
| 5.5MHz |
COLOUR SYS |
| AUTO |
FINE TUNE |
|
|
SKIP |
| OFF |
2 |
|
|
CH 2 |
|
|
|
| PROGRAMME |
RETURN |
| SEARCH |
TV/AV | E X I T | |
| ’STR’ | BUTTON STORE |
MANUAL TUNE |
|
|
MANUAL TUNE (via top panel)
It is also possible to use the control panel buttons on the top of the TV to tune individual programme positions
1 Press F (Top panel) until Tuning mode is reached.
2Press 
or 
to access Tuning mode.
3 Press F (Top panel) until Manual tune is reached.
TV/AV | STR | F | TV/AV |
|
|
|
4Press 
to move between Change programme, Search and Change TV system.
5Press 
or 
to change programme position or start search. When the desired station is found, press STR to store.
The programme position will flash.
Repeat above procedure to tune additional programme positions.
Press F at any time to exit the Tuning menu.
2 |
|
|
|
|
|
CH 2 |
|
|
|
|
|
5.5 MHz |
|
|
|
|
|
MANUAL TUNE |
|
|
| ||
: | SEARCH |
|
| ||
TV/AV | : | MOVE CURSOR |
| ||
STR | : | TO STORE |
|
| |
F | : | TO EXIT |
|
| |
STR |
| F | + / | TV / AV | |
Helpful Hint
1.If a clear picture cannot be obtained even when a Broadcast or AV signal is received, refer to the “Colour System” selection on page 15.
2.After the Manual tune is finished, press the Programme Number “Up” Button to confirm the tuning condition for each Programme Numbers. If some Programme Numbers are unused, it is possible to skip such Programme Numbers.
3.When using a VCR without video and audio input/output terminals, it is convenient to connect the aerial cable as indicated in the instruction manual of VCR and to set the designated channel to programme No.“0”. In that case, perform manual tune after setting the colour system and sound system in advance. Further, in multi- system VCR, it is more convenient to set the designated channel to several programme Numbers.
17
