Panasonic TH-103PF10EK manual Initial selections, Selecting the input signal

Initial selections

Selecting the input signal

Select the input signals to be connected by installing the optional Terminal Boards.

Press to select the input signal to be played back from the equipment which has been connected to the Plasma Display.

Input signals will change as follows:

INPUT1 INPUT2 INPUT3 PC

Press the INPUT “1”, “2”, “3” or “PC” input mode selection button to select the input mode.

This button is used to switch directly to INPUT mode.

These buttons can only display the slot which is installed. If you press the button whose slot is not installed, it automatically displays the current input signal.

When a dual input terminal board is attached, A or B is displayed depending on the selected input signal. (Ex. INPUT1A, INPUT1B)

Notes:

•Selecting is also possible by pressing the INPUT button on the unit.

•Input terminal will not be selected if the terminal board is not installed into the SLOT.

•Select to match the signals from the source connected to the component/

RGB input terminals. (see page 39)

•In 2 screen display, the same input mode cannot be selected for the main picture and sub picture.

•Image retention (image lag) may occur on the plasma display panel when a still picture is kept on the panel for an extended period. The function that darkens the screen slightly is activated to prevent image retention (see page 50), but this function is not the perfect solution to image retention.

ENTER/

+ /

VOL

- /

MENU

INPUT

Selecting the On-Screen Menu Language

Press to display the Setup menu.

Press to select the OSD Language.

Press to select your preferred language.

Selectable languages

English(UK)

Deutsch

Français

Italiano

Español

ENGLISH(US)

.......(Chinese)

.......(Japanese)

Setup	1/2
Signal
Component/RGB-in select
		RGB
Input label		PC
Power save		Off
Standby save		Off
Power management		Off
Auto power off		Off
OSD Language	English (UK)

13