Panasonic TH-103PF10EK manual Reduces power consumption, Customizing the Input labels

Reduces power consumption

• Power save:	When this function is turned On, luminous level of the Plasma Display is suppressed, so
	power consumption is reduced.
• Standby save:	When this function is turned On, power consumption of the microcomputer is reduced
	during power supply standby (see page 12, 14-15), so standby power of the set is reduced.

•Power management: The unit power supply is turned On or Off depending on whether or not there is a signal during PC input mode.

This function is enabled when it is turned On. (Only during input from PC (Mini D-sub) terminal)

• Auto power off:	Equipment power supply is turned Off when there is no signal.
	When this is set to On, the power supply of the unit goes Off 10 minutes after the input
	signals stop.
	This function is effective for input signals except input from PC (Mini D-sub) terminal.

1

2

Press to select “Power save” “Standby save” “Power management” “Auto power off”.

Press to select “On” or “Off”.

On Off

Setup	1/2
Signal
Component/RGB-in select
	RGB
Input label	PC
Power save	Off
Standby save	Off
Power management	Off
Auto power off	Off
OSD Language	English (UK)

3

Press to exit from Setup.	Note:
	“Power management” and “Auto power off” are effective
	during normal viewing (one picture screen) only.

Customizing the Input labels

This function can change the label of the Input signal to be displayed. Select the input signal which you would like to change its label before customizing the Input labels. (see page 13, 15)

Press to select Input label.

Press to change the Input label.

Setup	1/2
Signal
Component/RGB-in select
	RGB
Input label	PC
Power save	Off
Standby save	Off
Power management	Off
Auto power off	Off
OSD Language	English (UK)

Note:

While selecting an Input signal through Optional Terminal Board connected to Slot1, Slot2 and Slot3, the Input label will depend on each Optional Terminal Board.

Input labels for Slot1, Slot2, Slot3 and Mini D-sub:

[Slot1 Input] INPUT1 / VIDEO1 / COMPONENT1 / RGB1 / DIGITAL1 / PC1 / DVD1 / CATV1 / VCR1 / STB1

[Slot2 Input] INPUT2 / VIDEO2 / COMPONENT2 / RGB2 / DIGITAL2 / PC2 / DVD2 / CATV2 / VCR2 / STB2

[Slot3 Input] INPUT3 / VIDEO3 / COMPONENT3 / RGB3 / PC3 / DVD3 / CATV3 / VCR3 / STB3 [PC (Mini D-sub) input] PC / COMPONENT / RGB / DVD / STB

When BNC Dual Video Terminal Board (TY-FB9BD) is used, an “A” or “B” is added at the end of each input label, depending on the input selected (see below).

Addition sign	“A”	“B”
Selected Input	Composite	S VIDEO

33