Connections

AUDIO OUT Terminals connection

AC cord connection (see page 12)

R L

AUDIO OUT

Stereophonic sound code

audio equipment

line-in

– AC cord fixing

 

Close

 

Push until the

 

hook clicks.

Plug the AC cord into the display unit.

Open

Plug the AC cord until it clicks.

 

Fix the AC cord with the clamper.

2. Pull off.

 

Note:

Make sure that the AC cord is locked on both the1. Keep the knob pressed.

left and right sides.

Unplug the AC cord

Unplug the AC cord pressing the two knobs.

Note:

When disconnecting the AC cord, be absolutely sure to disconnect the AC cord plug at the socket outlet first.

Cable fixing bands Secure any excess cables with bands as required.

Pass the attached cable fixing band through the clip as shown in the figure.

To secure cables connected to Terminals, wrap the cable fixing band around them then pass the pointed end through the locking block, as shown in the figure.

While ensuring there is sufficient slack in cables to minimize stress (especially in the power cord), firmly bind all cables with the supplied fixing band.

1

2

To tighten:

To loosen:

 

Push the catch

Pull

 

Pull

SLOT1

AUDIO

R

 

AUDIO

 

 

L PR/CR/R PB/CB/B

Y/G

 

AUDIO

 

 

 

DVI-D IN

 

 

COMPONENT/RGB IN

 

 

SLOT2

 

 

 

 

 

SLOT3

 

 

 

 

 

 

PC IN

 

 

 

 

 

 

 

 

 

 

 

 

R L

SERIAL

AUDIO OUT

Optional Terminal Board Insert Slot (covered)

DVI-D IN Terminals (equivalent of DVI-D Terminal Board for PF Series (TY-FB9FDD)) (see page 11)

COMPONENT/RGB IN and Audio IN Terminals (equivalent of BNC Component Video Terminal Board (TY-42TM6A)) (see page 11)

From EXTERNAL monitor terminal on Computer (see page 9)

From SERIAL Terminal on Computer (see page 10)

From input on audio amplifier (see page 8)

Note: At factory shipment, Terminal boards are installed in SLOT 2 and SLOT 3.

8

Page 8
Image 8
Panasonic TH-103PF10EK manual Connections, Audio OUT Terminals connection, AC cord fixing Close, Open