![](/images/new-backgrounds/1230316/23031615x1.webp)
Remote Control Batteries
Requires two R6 batteries.
1.Turn the transmitter face down. Press and slide off the battery cover.
2.Install the batteries as shown in the battery compartment. (Polarity + or – must match the markings in the compartment.)
3.Replace the cover and slide in reverse until the lock snaps.
Two "R6" size
Helpful Hint:
For frequent remote control users, replace old batteries with
Alkaline batteries for longer life.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Observe the following precaution:
1.Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.
2.Do not combine a used battery with a new one.
3.Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).
4.Do not attempt to charge,
5.Battery replacement is necessary when remote control acts sporadically or stops operating the Plasma Display set.
8