Initial selections
Selecting the input signal
Select the input signals to be connected by installing the optional Terminal Boards.
Press to select the input signal to be played back from the equipment which has been connected to the Plasma Display.
Input signals will change as follows:
INPUT1 INPUT2A INPUT2B INPUT3 PC
SLOT2 is for dual input so that you can select INPUT2A or
INPUT2B for INPUT2.
INPUT2A : HDMI signal terminal in SLOT2
INPUT2B : HDMI signal terminal in SLOT2
Press the INPUT “1”, “2”, “3” or “PC” input mode selection button to select the INPUT mode.
Press 
to switch the input mode between INPUT2A and INPUT2B.
Notes:
•Selecting is also possible by pressing the INPUT button on the unit.
•Input terminal will not be selected if the terminal board is not installed into the SLOT.
•Select to match the signals from the source connected to the component/RGB input terminals. (see page 42)
•In 2 screen display, the same input mode cannot be selected for the main picture and sub picture.
•Image retention (image lag) may occur on the plasma display panel when a still picture is kept on the panel for an extended period. The function that darkens the screen slightly is activated to prevent image retention (see page 53), but this function is not the perfect solution to image retention.
INPUT MENU 
+/
ENTER/ 
Selecting the On-Screen Menu Language
Press to display the SET UP menu. Press to select OSD LANGUAGE.
Press to select your preferred language.
Selectable languages
English(UK) 
Deutsch
Français
Italiano
Español
ENGLISH(US)
.......(Chinese)
.......(Japanese)
Русский .......(Russian)
SET UP | 1/2 |
SIGNAL
| RGB |
|
|
INPUT LABEL | PC |
|
|
POWER SAVE | OFF |
|
|
STANDBY SAVE | OFF |
|
|
POWER MANAGEMENT | OFF |
|
|
AUTO POWER OFF | OFF |
|
|
OSD LANGUAGE | ENGLISH (US) |
20
