Panasonic TH-L32D25M Technical FAQs, HDMI Sound Screen Network Other, Problem, Actions, network

HDMI Sound Screen

Network

Other

Problem	Actions
	● Change the setting of “P-NR” in the Picture Menu (to remove
Chaotic image, noisy	noise). (p. 25)
	● Check nearby electrical products (car, motorcycle,
	fluorescent lamp).
No image can be displayed	● Is “Colour” or “Contrast” in the Picture Menu set to the
	minimum? (p. 24)
Blurry or distorted image	● Reset channels (p. 30).
(no sound or low volume)
Unusual image is displayed	● Turn off the TV with Mains power On / Off switch, then turn it
	on again.
No sound is produced	● Is “Sound Mute” active? (p. 10)
	● Is the volume set to the minimum?
Sound level is low	● Sound signal reception may be deteriorated.
or sound is distorted	● Set “MPX” in the Sound Menu to “Mono” (p. 25).
	● Set the sound setting of the connected equipment to “2ch L.PCM”.
Sound is unusual	● Check the “HDMI1 / 2 / 3 Input” setting in the Sound Menu. (p. 26)
	● If digital sound connection has a problem, select analogue
	sound connection. (p. 62)
Pictures from external	● Is the HDMI cable connected properly? (p. 53, 58, 59)
equipment are unusual	● Turn Off the TV and equipment, then turn them On again.
when the equipment is	● Check an input signal from the equipment. (p. 63)
connected via HDMI	● Use an equipment compliant with EIA/CEA-861/861B.
	● Check the LAN cable or Wireless LAN Adaptor is connected
Cannot connect to the	properly. (p. 44)
	● Check the connections and settings. (p. 44 - 47)
network	● Check the network equipment and network environment.
	● If the problem persists, consult your Internet Service Provider
	or telecommunications company.
Cannot select the file	● Is media server prepared? (p. 43)
during DLNA operations	● Check applicable data format. (p. 43)
Cannot operate VIERA	● Check the connections and settings. (p. 44 - 47)
CAST	● The server or connected line might be busy now.
TV goes into Standby	● Off Timer function is activated.	activated.
	● Auto power standby function is
mode	● The TV enters Standby mode about 30 mins. after analogue
	broadcasting ends.
	● Are the batteries installed correctly? (p. 3)
	● Has the TV been switched On?
The remote control does	● Point the remote control directly at the front of the TV (within
	about 7 m and a 30 degree angle of the front of the TV).
not work or is intermittent
	● Situate the TV away from sunshine or other sources of
	bright light not to shine on the TV’s remote control signal
	receiver.

Technical FAQs

69