Frequently Asked Questions
HDMI
Network
Digital TV
Other
Problem | Actions |
|
| |
| •Set the sound setting of the connected equipment to “2ch L.PCM”. | |||
Sound is unusual | •Check the [HDMI1 / 2 / 3 Input] setting in the Sound Menu. (p. 28) | |||
| •If digital sound connection has a problem, select analogue sound | |||
| connection. (p. 67) |
|
|
|
Pictures from external | •Check the HDMI cable is connected properly. | (p. 58, 63 - 65) | ||
equipment are unusual | •Turn the TV and equipment Off, then turn them On again. | |||
when the equipment is | •Check an input signal from the equipment. | (p. 68) | ||
connected via HDMI | •Use equipment compliant with | |||
| •Check the LAN cable or Wireless LAN Adaptor is connected properly. | |||
Cannot connect to the | (p. 50) |
| (p. 50 - 53) | |
•Check the connections and settings. | ||||
network | •Check the network equipment and network environment. | |||
| •If the problem persists, consult your Internet Service Provider or | |||
| telecommunications company. |
|
|
|
Cannot select the | •Is the media server prepared? | (p. 49) |
| |
file during DLNA |
| |||
operations | •Check applicable data format. | (p. 70 - 71) |
| |
Cannot access the | •Check the connections and settings. | (p. 50 - 53) | ||
Internet contents | •The server or connected line might be busy now. |
•Due to the digital reception technologies involved, quality of the Digital TV signals may be relatively low in some cases, despite good reception of Analogue TV channels.
•Install an aerial individually for the TV and VCR (or use a splitter).
TV |
|
| (Individual aerial) | |
Unable to receive |
|
| ||
| Aerial Output |
| ||
signals with a |
| Splitter | ||
|
|
|
| |
aerial | Aerial |
| Aerial Input | |
| Input | Aerial Output | ||
VCR | terminal | (Individual aerial) | ||
| ||||
|
|
|
•Check “Digital TV Signal Condition” (p. 34). If “Signal Quality” is Interference or frozen / displayed in red, check aerial. If problem persists, consult your local
disappearing image in | Panasonic dealer. | |
Digital TV | •Turn the TV off with the Mains power On / Off switch, then turn it On | |
| again. | |
The TV goes into | •Auto power standby function is activated. | |
Standby mode | •The TV enters Standby mode about 30 minutes after analogue | |
| broadcasting ends. | |
| •Are the batteries installed correctly? (p. 8) | |
The remote control | •Has the TV been switched On? | |
does not work or is | •Point the remote control directly at the front of the TV (within about | |
intermittent | 7 m and a 30 degree angle of the front of the TV). | |
•Situate the TV away from sunshine or other sources of bright light not | ||
| ||
| to shine on the TV’s remote control signal receiver. |
74