Using Network Function

This unit has a network function to control the network connected display with your computer.

Note:

To use the network function, set each “NETWORK SETUP” setting and make sure to set the “CONTROL I/F SELECT” to “LAN”. (see page 45)

When “LAN” is set, power indicator lights orange under the condition of power off with remote control (stand-by state).

Example of Network Connection

COMPUTER

Display (main unit, rear)

 

 

 

 

 

 

LAN cable (not supplied)

Hub or broadband router

Notes:

•Make sure the broadband router or hub supports 10BASE-T/100BASE-TX.

•To connect a device using 100BASE-TX, use “category 5” LAN cable.

•Touching the LAN terminal with a statically charged hand (body) may cause damage due to its discharge. Do not touch the LAN terminal or a metal part of the LAN cable.

•For instructions on how to connect, consult your network administrator.

Command Control

Network function of the unit can control the unit in the same way as serial control from a network.

Supported commands

Commands used in the serial control are supported. (see page 16)

Note:

Consult your local Panasonic dealer for detail instructions on command usage.

49