Panasonic VDR-D160GN manual Troubleshooting, 102, Problem Check points

Troubleshooting

Troubleshooting

	Problem	Check points
	This unit cannot be	≥ Is the battery fully charged?
	turned on.	# Charge the battery using the AC adaptor. (l 18)
		≥ If you do not use the unit for approximately 5 minutes, the
	This unit is turned off	power is automatically turned off to conserve the battery
		charge. To resume recording, turn the power back on.
	automatically.
		The power will not turn off automatically when the power
		save function (l 95) is set to [OFF].
	This unit does not stay	≥ Is the battery low?
		# If the remaining battery power indication is flashing or the
	on long enough.	message “LOW BATTERY.” is displayed, the battery has run
		down. Charge the battery. (l 18)
	A clicking sound is heard	≥ This is the sound of the lens moving and is not a
	when the power is turned
	off.	malfunction.
		≥ Is the battery fully charged?
		# Charge it with the AC adaptor. (l 18)
		≥ Are you using the battery in an extremely cold place?
	Battery runs down	# The battery is affected by ambient temperature. In cold
		places, the operating time of the battery becomes shorter.
	quickly.
		≥ Has the battery worn out?
		# The battery has a limited life. If the operating time is still too
		short even after the battery is fully charged, the battery has
		worn out and can no longer be used.
	This unit cannot be	≥ Press the RESET button. (l 105) If normal conditions are
	operated though	not restored yet, remove the battery or AC adaptor, wait
	powered up.	about 1 minute and then reconnect the battery or AC
		adaptor. Then about 1 minute later, turn on the power
	This unit does not	again. (Conducting the above operation when the access
	operate normally.	lamp is on may destroy the data on the disc or card.)
		≥ Has the demonstration started?
		# If you set [DEMO MODE] to [ON] without inserting a disc or a
Others	The screen has changed	card in disc recording mode or card recording mode, the unit
		is automatically set to the demonstration mode for
	suddenly.
		introducing its functions. Normally this should be set to
		[OFF]. Press the MENU button, then select [SETUP] #
		[DEMO MODE] # [OFF] and press the joystick.

102

LSQT1184