Indications

CHECK CARD.

This card is not compatible or it cannot be recognized by the

unit.

 

CARD LOCKED.

The write protection switch on the SD card is set to LOCK.

(l 16)

 

CARD FULL.

The SD card is full so no further data can be recorded. Delete

unnecessary files (l 76) or insert a new SD card.

 

PUSH THE RESET

≥ An irregularity in the unit has been detected. Press the

RESET button to restart the unit. (l 105)

SWITCH.

≥ The disc is scratched or dirty. Eject the disc and clean it.

 

(l 17) If there are scratches on the disc, use a new disc.

CHANGE TO MANUAL

 

MODE.

You are attempting to use a function that cannot be used

CANCEL NIGHT VIEW

simultaneously.

 

MODE

 

CHANGE MODE TO USE

The USB cable is connected in the recording mode.

USB.

 

DISCONNECT USB

The unit cannot correctly establish the connection to the

computer or printer. Disconnect and then reconnect the USB

CABLE.

cable or check the [USB FUNCTION] setting on this unit.

 

 

 

About recovery

It is possible that the system cannot complete writing of a file normally when, for example, power is turned off for some reason during recording or editing.

If faulty management information is found when a disc is accessed, the following message may appear. Be sure to follow the messages. (Repairing may take time depending on the error.)

DISC ERROR HAS OCCURRED. REPAIR DISC NOW?

When you repair the disc, use a battery with sufficient battery power or the AC adaptor. Even if the power is turned off without repairing the disc, you can repair the disc when you turn the power on again.

Depending on the condition of the data, it may not be possible to completely repair the data.

If the disc is removed without it being repaired, you will no longer be able to playback the scenes recorded before the power went off.

Do not repair a disc that has been recorded on another device. This may cause the loss of data or the disc.

Others

99

LSQT1184

Page 99
Image 99
Panasonic VDR-D160GN manual About recovery