Notes:
•Masking or adjusting the detection level is needed to prevent malfunction under the following condi- tions:
•When shooting an object under flickering fluores- cent light or shooting in ELC.
•When leaves or curtains etc. are swayed by the wind.
•When the object is lighted by lighting equipment that constantly turns on and off.
•It takes about 0.2 seconds for the alarm signal to reach the alarm terminal of the VCR after the cam- era detects the object.
Because the alarm signal is multiplexed on the video signal, it may be mistakenly interpreted by other video equipment as a time code signal.
Therefore, when the camera is not used in a Panasonic Intelligent CCTV System, select OFF to prevent the above from occurring.
9.Lens Drive Signal Selection
(LENS DRIVE)
This item is used to select the type of auto iris lens drive signal to be supplied to the lens from the auto iris lens connector.
| ** CAM SET UP ** | ||
CAMERA ID | OFF | ↵ | |
ALC/ELC | ALC | ↵ | |
SHUTTER | OFF | ||
AGC |
| ON | |
SENS | UP | OFF |
|
SYNC |
| INT |
|
WHITE BAL | ATW1 ↵ | ||
MOTION DET | OFF |
| |
LENS | DRIVE | DC |
|
END | SET UP ENABLE | ||
1.Move the cursor to the LENS DRIVE parameter.
2.Select DC if you are using the auto iris lens that requires a DC drive signal.
Select VIDEO if you are using the auto iris lens that requires a video drive signal.
