Panasonic WV-CS574 White Balance White BAL, Auto-Tracing White Balance Mode ATW1/ ATW2

5. Move the cursor to COARSE with the joystick.

** SYNC **
V PHASE
COARSE	1	(1--16)
FINE	••••••••
	-		+

RET

6.Match the vertical phases for both video output sig- nals as closely as possible with the joystick. The coarse adjustment can be performed in steps of 22.5 degrees (16 steps) with the joystick.

- -1 (1 -	16):		0 degrees
2 (1 - - -	16):		22.5 degrees
16 (1 - -	-	16): 337.5 degrees

Note:

After the 16th step, the adjustment level returns to the first step.

7. Move the cursor to FINE by using the joystick.

** SYNC **
V PHASE
COARSE	1(1--16)
FINE
		••••••••
		-	+

RET

8.Match the vertical phase for both video output sig- nals as closely as possible with the joystick.

** SYNC **
V PHASE
COARSE	4(1--16)
FINE
		••••••••
		-	+
RET
** SYNC **
V PHASE
COARSE	1(1--16)
FINE		••••••••
		-	+

RET

Notes:

•When the "" cursor reaches the "+" end, it jumps back to "–". At the same time, COARSE is incre- mented by one step to enable a continuous adjustment. The reverse takes place when the "" cursor reaches the "–" end.

•When the joystick is kept at the right or left for one second or more, the "" cursor moves quick- ly.

•To reset COARSE and FINE to the preset values, press the F3 button of WV-CU650. For WV-RM70, press the right and left switches simultaneously. COARSE is preset to zero-crossing of the AC line phase.

•If the AC line phase contains spike noise, etc., the vertical phase of the video output signal may be disturbed.

●White Balance (WHITE BAL)

(1)Auto-Tracing White Balance Mode (ATW1/ ATW2)

1. Move the cursor to WHITE BAL and select ATW1 with the joystick. The white balance of the camera is automatically adjusted.

** SET UP **

CAMERA ID		OFF
ALC/MANUAL		ALC
SHUTTER		AUTO
AGC		ON(MID)
SENS UP		OFF
SYNC		INT
WHITE BAL		ATW1
MOTION DET		OFF
AF MODE		AUTO L
RET	SPECIAL2

2.For fine adjustment of ATW1/ATW2, press the CAM (SET) button. The ATW1/ATW2 fine adjustment menu appears on the monitor screen.

** ATW1 **

R••••••••

- +

B••••••••

- +

RET

3.Move the cursor to RET with the joystick and press the CAM (SET) button to return to the SET UP menu.

-46-