Panasonic WV-CS954 Special Settings, Using the Special Setup Menu, Adjusting Picture Quality

SPECIAL SETTINGS

■Using the Special Setup Menu

Display the special setup menu from the setup menu to adjust picture quality.

First, display the special setup menu.

1.Display the setup menu (page 21), move the cursor to SPECIAL O, and then press the CAM (SET) button.

This will display the special setup menu.

**SPECIAL SETUP**
CHROMA GAIN	••••••I••
AP GAIN	•••I•••••
PEDESTAL	••I••••••
HUE	••••I••••
	-	+

PIX OFF	→PUSH
REFRESH		SET
CAMERA RESET	→PUSH	SET

SER.NO. BFB03964

RET TOP

●Adjusting Picture Quality

Use the following procedure to adjust picture quality.

1.Move the cursor to CHROMA GAIN, and then tilt the joystick left or right to adjust the CHROMA GAIN level.

2.Move the cursor to AP GAIN, and then tilt the joystick left or right to adjust the aperture level.

3.Move the cursor to PEDESTAL, and then tilt the joystick left or right to adjust the PEDESTAL level.

4.Move the cursor to HUE, and then tilt the joystick left or right to adjust the chroma phase (color tone).

5.Move the cursor to PIX OFF O, and then press the CAM (SET) button.

This will display the PIX OFF menu. Perform the following steps to perform blemish compensation on the pixels.

6.Select a position that has a blemish with the PIX OFF number, and then press the CAM (SET) button. This will display the blemish compensation pattern setting screen.

(1)Use the joystick to move the cross cursor ( ) to the location of the defective pixels.

(2)Move the cursor around the display until there are no more white spots (blemishes) visible, and then press the CAM (SET) button.

This will store the blemish compensation pattern.

(3)This returns to the PIX OFF menu.

An asterisk (*) to the right of a PIX OFF number indicates that the number has a blemish compensation pattern assigned to it.

		*	** PIX OFF **
	1		2*	3*	4*
5*			6*	7*	8
9			10	11	12
13			14	15	16

000000 RET TOP

To delete a blemish compensation pattern

(1)On the PIX OFF menu screen, select of the pattern you want to delete, and press the CAM (SET) button.

This will display the blemish compensation pattern setting screen.

(2)Press the F3 button.

(3)This returns to the PIX OFF menu.

This will delete the blemish compensation pattern and remove the asterisk (*) to the right of the applicable pattern number.

7.To correct for camera deviation from the preset

positions during operation, move the cursor to →PUSH SET to the right of REFRESH, and then

press the F3 button.

The refresh function corrects the camera position when it starts to deviate from the preset positions. If you are not using the WV-CU650C system controller, perform one of the following steps to correct the camera position.

8.To reset the camera to its initial default settings, move the cursor to →PUSH SET to the right of

CAMERA RESET, and then press the F4 button. This resets the camera to it initial factory default settings. Note, however, that this does not change the camera's preset position, AUTO PAN, patrol, RS485, blemish compensation patter and password settings.

If you are not using the WV-CU650C system controller, perform one of the following steps to reset the camera.

Note: If above operations are performed while the cursor is located at any other item besides CAMERA RESET, further menu operations may become impossible. If this happens, use the procedure under "Displaying the Setup Menu" on page 21 to re-display the menu.

-39-