Radio disturbance
When this product is used near TV/radio antenna, strong electric field or magnetic field (near a motor, a transformer or a power line), images may be distorted and noise sound may be produced.
Take notice of humidity.
Install this product when the humidity is low. If this product is installed during rainfall or at a high humidity, the inside may be exposed to moisture and the dome cover may become foggy.
Heater unit
This product is equipped with an internal heater unit for use in cold climates. When connected with a PoE+ hub/ device, the product can operate in an environment below
SW395 . The heater unit turns on automatically when the temperature inside the product drops below +10 °C {50 °F}. However, in an extremely
When this product is installed and operated in low tem- peratures below
*When using this product at temperatures of
Influence on images and their quality
This product has no wiper unit. Under the following condi- tions, image quality may deteriorate or images may not be viewed properly.
(1)Influence by rainfall
Due to the wind that accompanies rainfall, raindrops may fall on the dome cover. That may make images less viewable.
(2)Influence by snowfall
Due to the wind that accompanies snowfall, snow may fall on the dome cover. That may partially make surveillance images inviewable. (The extent of inview- ability may vary depending on the amount of snowfall and the quality of snow.)
(3)Influence by dust in the air or gas emission from vehi- cles
Depending on the installation environment, dome cover may be dirty due to dust in the air or gas emis- sion from vehicles. That may degrade the quality of images.
Check before connection
Compatibility of devices are restricted. Before connec- tions, check the ratings and dimensions of the devices to be used.
Contact your dealer for details.
Router
When connecting this product to the Internet, use a broadband router with the port forwarding function (NAT, IP masquerade).
Refer to the Operating Instructions (included in the
Procure fixing screws separately.
The screws that secure this product are not supplied. Prepare them according to the material and strength of the area where the product is to be installed.
PoE+ (Power over Ethernet Plus)
Use a PoE+ hub/device that is compliant with IEEE802.3at standard.
It is impossible to supply the power to this product from a PoE hub that is compliant with IEEE802.3af standard.
Time & date setting
It is necessary to set the time & date before putting this product into operation. Refer to the Operating Instructions on the provided
13