ParaBody 400101 manual X 2-3/4 35 3/8 X

	26	28
		14
		78
	51	51
3/8 X 2-3/4”	38	35 3/8 X 1”
FIGURE 24

STEP 24

•Securely attach BACK SEAT PAD (26) to BACK PAD SUPPORT (14) using two 3/8 X 2-3/4” (38) and two 3/8” WASHERS (51).

•Securely attach LEG SEAT PAD (28) to HINGE TABS (78) using two 3/8 X 1” (35) and two 3/8” WASHERS (51) as shown in FIGURE 24.

STEP 25

Assemble the LEG CURL/EXTENSION (4) to the BENCH FRAME (15) using the following steps:

		50	1/2” LOW
			HEIGHT
			67
	15	3/8 X 1”
	35
45 1/2 X 4-1/2”	90		4
FIGURE 25	51
	48	18

•Insert two 1/2” FLANGE BEARINGS (67) into the LEG CURL/EXTENSION (4).

•Assemble the LEG CURL/EXTENSION (4) to the BENCH FRAME (15) using one 1/2 X 4-1/2” (45) and one 1/2” LOW HEIGHT LOCKNUT (50). (NOTE: Securely tighten, then back nut off 1/4 turn to allow the LEG CURL/EXTENSION (4) to rotate freely.)

•Securely fasten 227” CABLE (90) to the LEG CURL/EXTENSION (4) using one 3/8 X 1” BOLT (35), one 3/8” WASHER (51), and one 3/8” LOCKNUT (48) as shown in FIG- URE 25.