ParaBody 400101 manual Step

1	55
	2	54
		15
71		95
FIGURE 21

STEP 21

•Slide the 1/2” DIA U-PIN (55) through the bushing in the WOLFF SLEEVE (2) then force 1/2” PAL NUT (54) over end of 1/2” DIA U-PIN (55).

•Slide the WOLFF SLEEVE (2) over the BENCH FRAME (15). (NOTE: Make sure the spring pin barrel is facing as shown in

FIGURE 21.)

•Slide the BENCH FRAME (15) between the angles on the FRAME SUPPORT (1).

•Securely assemb1e one 3/8” SPRING PIN ASSEMBLY (71) and one THUMBSCREW (95) to the WOLFF SLEEVE (2).

1
42 1/2 X 3”
		50
		15
		49
52
18
43 1/2 X 3-1/2”	10	50 1/2” LOW HEIGHT
		1/2 X 3” 42
FIGURE 22

STEP 22

•Securely fasten BENCH FRAME (15) to the BASE (10) using one 1/2 X 3” BOLT (42) and one 1/2” LOW HEIGHT LOCKNUT (50).

•Securely attach BENCH FRAME (15) to the FRAME SUPPORT (1) using one 1/2” X 3” BOLT (42) and one 1/2” LOCKNUT (49).

•Attach two 2 X 16-1/2” PLATES (18) to the BENCH FRAME (15) using one 1/2 X 3-1/2” BOLT (43), two 1/2” WASHERS (52), and one 1/2” LOCKNUT (49). Make sure 1/2” WASHER (52) is on inside of plate as shown on FIGURE 22. (NOTE: Securely

tighten, then back nut off 1/4 turn to allow the 2 X 16-1/2” PLATES (18) to rotate freely.)

16